Power cutting at higher rev range

ZX2R, ZXR400, ZXR750, ZX6R, ZX7R, ZX9R & ZX12R & others.
Post Reply
User avatar
tim
VIP MEMBER
VIP MEMBER
Posts: 5815
Joined: Wed Dec 10, 2008 10:12 pm
Bike: ZX6R
State: New South Wales
Location: Sydney, NSW

Power cutting at higher rev range

Post by tim »

Hi all,

On a ride on the weekend the 08 zx6r was cutting out/down on power when:

under load, and
hot, and
into the higher rev range (started loss at around 8k, dead above 10k)

Does happily rev in neutral.

Thinking to first clean the fuel pump/pickup filter.
Next replace plugs (hasn't been done in years)
Clean injectors?
Throttle bodies?
PC3 getting hot and failing?

Any thoughts?

Cheers,
Tim.
2008 ZX6R Special Edition
User avatar
MadKaw
Administrator
Administrator
Posts: 9671
Joined: Tue Apr 20, 2004 4:33 pm
Bike: ZX10R
State: New South Wales
Location: Windsor or the Creek..
Contact:

Re: Power cutting at higher rev range

Post by MadKaw »

Yep, all the above..
Sounds like a fuel blockage or pump issue.
Maybe try a different map on the PC or remove it see if that is an issue.
Dave
2010 Z1000
ex bikes
05 ZX-10R Race Bike - No.77
95 ZXR750R M Race Bike - No. 75
98 ZX9R Race Bike - No. 000
zx6r, zx7r, GPX750, GPX500, lots of KX's.
Image
I ride way too fast to worry about cholesterol
User avatar
KiwiMat
KSRC Member
KSRC Member
Posts: 197
Joined: Sun Jun 03, 2012 8:50 pm
Bike: ZX12R
State: New South Wales
Location: Sydney

Re: Power cutting at higher rev range

Post by KiwiMat »

also...

cant hurt and cheap as, to run some decent injector cleaner through the bike, but i had exactly the same prob on a recent GSXR600 i fixed up, put a $120 fuel pump kit through it, went hard after that, i still reakon the injector cleaner helped.
Pinched or bend fuel line that bends more when hot?

just throwing a few out there.

cheers
KiwiMat
ZX12R - 2005
GSXR750 - 2022
FZR250 - 1990
ZXR250A... project
User avatar
tim
VIP MEMBER
VIP MEMBER
Posts: 5815
Joined: Wed Dec 10, 2008 10:12 pm
Bike: ZX6R
State: New South Wales
Location: Sydney, NSW

Re: Power cutting at higher rev range

Post by tim »

Thanks guys! Haven't got back to it yet, but yeah fuel line is a possibility (I did have the tank up refitting some parts) and will try some injector cleaner.

I did a fuel pump kit 2 years ago - this one

https://www.ebay.com.au/itm/154365836327

not sure on the quality.

Will update
Cheers
2008 ZX6R Special Edition
User avatar
James
VIP MEMBER
VIP MEMBER
Posts: 337
Joined: Fri May 28, 2004 8:48 am
Bike: Other Kawi
State: New South Wales
Location: Sydney

Re: Power cutting at higher rev range

Post by James »

I had the same issue on a ZX7 that was due to the battery. I replaced it and all good!
User avatar
Wattie
VIP MEMBER
VIP MEMBER
Posts: 10041
Joined: Mon Oct 31, 2005 12:23 pm
Bike: ZX10R
State: New South Wales
Location: Bligh Park

Re: Power cutting at higher rev range

Post by Wattie »

James wrote:I had the same issue on a ZX7 that was due to the battery. I replaced it and all good!
yep, or even check the terminals are tight. 8)
Wattie #55
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
Post Reply