Power Commander Question..Maps

[Maddog]

Hi all,
Hoping someone can help.

Just installed a Power Commander PC III to the 05 ZX6R.
The bike has a Yoshi RS-5 slip on muffler and K&N air filter installed.

The problem is, I can only find a map for the Yoshi full system.
No map available for just the slip on muffler.

There are maps available for other slip on mufflers Akro ,Two Bros etc
Do I run the Yoshi full system map or perhaps use one of the other slip on maps.

Any help or suggestions would be great

Cheers.

[Cwidova]

i ran an akrapovic slip on map with the muzzys and it worked fine....

[tim]

Yup slip on map, not full system.

[fireyrob]

Like has been said run a slipon map. Download 2 or 3 and compare them. They are probably all similar

[Maddog]

Thanks guys
My thoughts were to use the Akro map
Seems kinda weird they do the Yoshi full system but not the slip on
Will try a couple on the next outing and compare them on the bum dyno

Cheers.

[Mattjin]

Go have it tuned properly.

Loading unknown maps is like walking through a minefield. Most of the maps are from US bikes and most of them have different tunes from factory.

[born green]

Go have it tuned properly.

Loading unknown maps is like walking through a minefield. Most of the maps are from US bikes and most of them have different tunes from factory.

yep, said that before, custom map it and be done with it... at least that way ur getting the best out of it.. which is what we want i would think, ok it cost a bit... mines only been done twice in 5 years and runs as sweet as..........

[Maddog]

Thanks guys.

I had every intention to get it custom mapped in the near future.
Was just hoping, I could drop a map in it to gain a bit for now.
If no good with the couple I'll try on the next day out I'll go back to stock
Just finishing a few other things on the bike first then its off to the dyno for a tune and remap...(when/if the cashflow permits)