Tomorrow I have to take the Shadowfax from Wollongong to Sydney so that Kent can fit new brackets and stuff to the frame for the seat/tank/fairing unit. Unfortunately, my "wheel" man has been unable to finish and deliver my wheels. The bikes needs to be on wheels and tyres so that Kent can move it around and also judge the line of the bike and how the fairing/seat/tank will fit.
SO, what I need, like today, if possible, or maybe early tomorrow, is a set of 18" wheels, with tyres, that I can BORROW so we can get the bike to Sydney on the trailer and Kent can start work on it. I know this is asking a lot and I know it's late notice, but I'm really between a rock and a hard place here.
Any help would be appreciated.
Phil 0413 626 660
Thanks again.
Help needed - URGENTLY - [Sydney/Wollongong]
- fezzick
- KSRC Member
- Posts: 369
- Joined: Tue Nov 17, 2009 8:41 am
- Bike: Z1000
- State: New South Wales
- Location: Wollongong, NSW
- Contact:
Help needed - URGENTLY - [Sydney/Wollongong]
I started out with nothing and I still have most of it left. Phil
www.halfofmylife.com
www.halfofmylife.com
- Wattie
- VIP MEMBER
- Posts: 10041
- Joined: Mon Oct 31, 2005 12:23 pm
- Bike: ZX10R
- State: New South Wales
- Location: Bligh Park
Help needed - URGENTLY - [Sydney/Wollongong]
I'm towing an emtpy horse float from nowra to syd tonight...
Any help?
Any help?
Wattie #55
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
- fezzick
- KSRC Member
- Posts: 369
- Joined: Tue Nov 17, 2009 8:41 am
- Bike: Z1000
- State: New South Wales
- Location: Wollongong, NSW
- Contact:
Re: Help needed - URGENTLY - [Sydney/Wollongong]
Thanks for the offer, mate, but not really. I can't deliver the bike to Kent until tomorrow and I really need to talk to him too. Getting it up there isn't the issue. Getting it onto a set of wheels, is.
I started out with nothing and I still have most of it left. Phil
www.halfofmylife.com
www.halfofmylife.com
- MAXUMIS
- KSRC Contributor
- Posts: 1034
- Joined: Fri Jul 09, 2010 7:16 pm
- Bike: ZX12R
- State: New South Wales
Re: Help needed - URGENTLY - [Sydney/Wollongong]
Mate i do have a set of zx12 wheels that 'might' at least get it rolling.
life starts at 200 kph!
- fezzick
- KSRC Member
- Posts: 369
- Joined: Tue Nov 17, 2009 8:41 am
- Bike: Z1000
- State: New South Wales
- Location: Wollongong, NSW
- Contact:
Re: Help needed - URGENTLY - [Sydney/Wollongong]
Thanks, mate, but they would be too wide, the bike only has little narrow 18" ones. I'm going to take the chassis up tomorrow and then have a look at the wreckers at Alexandria and see if I can buy any set that will fir just so Kent can roll it around.
I started out with nothing and I still have most of it left. Phil
www.halfofmylife.com
www.halfofmylife.com