SYD - Where should i go for servicing
SYD - Where should i go for servicing
Hey guys,
Im due for a service and need to decide where im going to take my pride and joy. I used to go to Narellan Kawasaki as you guys on the forum here reccomended them but they have since closed down, can anyone reccomend one of the other sydney based dealers? I would take it to Flywheels as they are a sponsor but they are a tad out of my way and im not sure if they are open on weekends for servicing....
So unless its a landslide for Flywheels i was thinking either Aitkens or Kelen as i live out that way...
Im due for a service and need to decide where im going to take my pride and joy. I used to go to Narellan Kawasaki as you guys on the forum here reccomended them but they have since closed down, can anyone reccomend one of the other sydney based dealers? I would take it to Flywheels as they are a sponsor but they are a tad out of my way and im not sure if they are open on weekends for servicing....
So unless its a landslide for Flywheels i was thinking either Aitkens or Kelen as i live out that way...
- Technik
- KSRC Member
- Posts: 123
- Joined: Tue Feb 27, 2007 10:16 pm
- Bike: Don't have one
- State: New South Wales
- Location: Melbourne
- Contact:
Re: SYD - Where should i go for servicing
+1 i wanted to find out too...my bike is due for a major 24,000km, reckon it is gonna cost me a bomb.
has anyone had any experienced with Sydney City Motorcycle at Kogarah? think that's the closest one to where I live.
has anyone had any experienced with Sydney City Motorcycle at Kogarah? think that's the closest one to where I live.
-
- KSRC Member
- Posts: 397
- Joined: Mon Jan 08, 2007 11:50 am
- Bike: ER6
- State: New South Wales
- Location: Padstow NSW
Re: SYD - Where should i go for servicing
I bought my bike from Flywheels and had the 1000k service done there. They did it on a saturday morning for me.
I would recommend them but I suppose it depends on whether you want to travel that far.
Jen
I would recommend them but I suppose it depends on whether you want to travel that far.
Jen
2007 ER6n
2000 GPX250R - RIP 22/04/07
2000 GPX250R - RIP 22/04/07
- Glen
- VIP MEMBER
- Posts: 7268
- Joined: Mon Apr 18, 2005 10:30 am
- Bike: ZRX
- State: New South Wales
- Location: Kellyville
Re: SYD - Where should i go for servicing
I had the 12000 on the 10 done by Mick at Castle Hill Motorcycles. He's very good and doesn't rip you off.
It's really all about standing around drinking Dave's beer.
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
- MadKaw
- Administrator
- Posts: 9671
- Joined: Tue Apr 20, 2004 4:33 pm
- Bike: ZX10R
- State: New South Wales
- Location: Windsor or the Creek..
- Contact:
Re: SYD - Where should i go for servicing
Theres also Glen at All Fix automotive in Castle Hill.
Dave
2010 Z1000
ex bikes
05 ZX-10R Race Bike - No.77
95 ZXR750R M Race Bike - No. 75
98 ZX9R Race Bike - No. 000
zx6r, zx7r, GPX750, GPX500, lots of KX's.

I ride way too fast to worry about cholesterol
2010 Z1000
ex bikes
05 ZX-10R Race Bike - No.77
95 ZXR750R M Race Bike - No. 75
98 ZX9R Race Bike - No. 000
zx6r, zx7r, GPX750, GPX500, lots of KX's.

I ride way too fast to worry about cholesterol
- Glen
- VIP MEMBER
- Posts: 7268
- Joined: Mon Apr 18, 2005 10:30 am
- Bike: ZRX
- State: New South Wales
- Location: Kellyville
Re: SYD - Where should i go for servicing
....and he's got a cool nameMadKaw wrote:Theres also Glen at All Fix automotive in Castle Hill.

It's really all about standing around drinking Dave's beer.
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
Re: SYD - Where should i go for servicing
my bike is still in warranty so im looking to take it to kawasaki dealer, can anyone reccomend one of them?
or are they all as bad as eachother, this thread has had 30 views and not one good comment about a factory dealer
or are they all as bad as eachother, this thread has had 30 views and not one good comment about a factory dealer

- Frank
- KSRC Contributor
- Posts: 1432
- Joined: Tue Jun 07, 2005 10:23 pm
- Bike: ZX9R
- State: New South Wales
- Location: Shaggers Ridge, Sydney
Re: SYD - Where should i go for servicing
You dont need to go to a dealer to keep your warranty, any licenced bike mechanic can service your bike and it wont effect your warranty. The only reason to take it to a dealer (in MY opinion is to try and get any warranty issues sorted), and as long as your as service book is stamped.Vukie wrote:my bike is still in warranty so im looking to take it to kawasaki dealer, can anyone reccomend one of them?
or are they all as bad as eachother, this thread has had 30 views and not one good comment about a factory dealer
I take my bike to Glenn at All Fixed Automotive, he has looked after all of my bikes. The only time I went to a dealer was to get an oil pressure switch replaced under warranty on my ER-5 a couple of years ago.
GO THE BLUES
Life time member of PETA:-
PEOPLE for the EATING of TASTY ANIMALS
Member of SRT
1998 Kawasaki ZX9R Track Bike
2014 Nissan Navara
Life time member of PETA:-
PEOPLE for the EATING of TASTY ANIMALS
Member of SRT
1998 Kawasaki ZX9R Track Bike
2014 Nissan Navara
- mike-s
- Apprentice Post Whore :-)
- Posts: 6142
- Joined: Sat Aug 07, 2004 5:43 am
- Bike: Suzuki
- State: New South Wales
- Location: Arncliffe, Sydney
- Contact:
Re: SYD - Where should i go for servicing
hmm, its a shame Narellan is closed, I can't think of anywhere near Campbelltown.
It reminds me, i should get my bike in for a service, it's not had one since before i bought it.... which was uhm, about 18kkm ago. Having said that though, i have been doing the basics (though i admit i havent taken the tank off yet!!!!)
It reminds me, i should get my bike in for a service, it's not had one since before i bought it.... which was uhm, about 18kkm ago. Having said that though, i have been doing the basics (though i admit i havent taken the tank off yet!!!!)
- Technik
- KSRC Member
- Posts: 123
- Joined: Tue Feb 27, 2007 10:16 pm
- Bike: Don't have one
- State: New South Wales
- Location: Melbourne
- Contact:
Re: SYD - Where should i go for servicing
[quote="Vukie"] this thread has had 30 views and not one good comment about a factory dealer
[/quote]
i know, think i might just head off to flywheel - sounds like they aint as dodgy as other mechanics.

i know, think i might just head off to flywheel - sounds like they aint as dodgy as other mechanics.
-
- KSRC Regular
- Posts: 995
- Joined: Mon May 22, 2006 10:27 am
- Bike: ZXR750
- State: New South Wales
- Location: Hills District NSW
Re: SYD - Where should i go for servicing
I take my bike to Kelens for all its services. My bike is far from new though. It is a 93 ZXR.
Ken the mechanic is also far from new and has shit loads of experience and he always seems to take care with the little things like not scratching the shit out of the paint with tools.
That is a regular problem with alot of mechanics. They are good at what they do but don't take any care for the bike they are working on.
Ken the mechanic is also far from new and has shit loads of experience and he always seems to take care with the little things like not scratching the shit out of the paint with tools.
That is a regular problem with alot of mechanics. They are good at what they do but don't take any care for the bike they are working on.
Remember, half the people you know are below average.
Bike 93 ZXR750
05 ZRX1200
05 DRZ400
Bike 93 ZXR750
05 ZRX1200
05 DRZ400
- rooster
- VIP MEMBER
- Posts: 2300
- Joined: Mon Mar 21, 2005 7:39 am
- Bike: Z1000
- State: New South Wales
- Location: FULLY FLEDGED SHIRE HOBBITT
Re: SYD - Where should i go for servicing
On Two Wheels is now the Kwaka dealer for Campbelltown. Haven't had any dealings with them though. I take my bike to Campbelltown Motorcycles in Blaxland Road good guys, tell them Eric sent you, they also have the dyno there if you want to go the whole hog on getting the bike running properly.





If life is like a box of chocolates, why do I always get the laxettes?
Re: SYD - Where should i go for servicing
Did a quick ring around to a few dealers for the 6 month service on a ZX6R:
Kelen: $200 + parts
Aitkens: $255 + parts
Flywheels: $500
- the 10% memebr discount is still $450
Kelen: $200 + parts
Aitkens: $255 + parts
Flywheels: $500


- BikerBoy
- KSRC Member
- Posts: 275
- Joined: Fri Oct 06, 2006 2:14 pm
- Bike: Z1000
- State: New South Wales
- Location: Australia
Re: SYD - Where should i go for servicing
Yea any dealer around central sydney City will be much more expensive than in the outer suburbs...
Check out http://www.budgetbikes.com.au" target="_blank
401 Hume Hwy,
Yagoona 2199 NSW
They did my tuning, major service, shimming etc. Forgot the Guys name but its owned by 2 brothers who
were really genuine and did a great job.
Highly recommend them
Check out http://www.budgetbikes.com.au" target="_blank
401 Hume Hwy,
Yagoona 2199 NSW
They did my tuning, major service, shimming etc. Forgot the Guys name but its owned by 2 brothers who
were really genuine and did a great job.
Highly recommend them
-
- KSRC Regular
- Posts: 995
- Joined: Mon May 22, 2006 10:27 am
- Bike: ZXR750
- State: New South Wales
- Location: Hills District NSW
Re: SYD - Where should i go for servicing
Vukie wrote:Did a quick ring around to a few dealers for the 6 month service on a ZX6R:
Kelen: $200 + parts
Aitkens: $255 + parts
Flywheels: $500![]()
- the 10% memebr discount is still $450
Is the $500 for labour only or does that cover parts also???
Remember, half the people you know are below average.
Bike 93 ZXR750
05 ZRX1200
05 DRZ400
Bike 93 ZXR750
05 ZRX1200
05 DRZ400