SYD - Where should i go for servicing

General Discussion
Vukie
KSRC Member
KSRC Member
Posts: 134
Joined: Wed Mar 14, 2007 10:07 pm
Location: Sydney

SYD - Where should i go for servicing

Post by Vukie »

Hey guys,

Im due for a service and need to decide where im going to take my pride and joy. I used to go to Narellan Kawasaki as you guys on the forum here reccomended them but they have since closed down, can anyone reccomend one of the other sydney based dealers? I would take it to Flywheels as they are a sponsor but they are a tad out of my way and im not sure if they are open on weekends for servicing....

So unless its a landslide for Flywheels i was thinking either Aitkens or Kelen as i live out that way...
User avatar
Technik
KSRC Member
KSRC Member
Posts: 123
Joined: Tue Feb 27, 2007 10:16 pm
Bike: Don't have one
State: New South Wales
Location: Melbourne
Contact:

Re: SYD - Where should i go for servicing

Post by Technik »

+1 i wanted to find out too...my bike is due for a major 24,000km, reckon it is gonna cost me a bomb.

has anyone had any experienced with Sydney City Motorcycle at Kogarah? think that's the closest one to where I live.
Jennysc
KSRC Member
KSRC Member
Posts: 397
Joined: Mon Jan 08, 2007 11:50 am
Bike: ER6
State: New South Wales
Location: Padstow NSW

Re: SYD - Where should i go for servicing

Post by Jennysc »

I bought my bike from Flywheels and had the 1000k service done there. They did it on a saturday morning for me.

I would recommend them but I suppose it depends on whether you want to travel that far.

Jen
2007 ER6n
2000 GPX250R - RIP 22/04/07
User avatar
Glen
VIP MEMBER
VIP MEMBER
Posts: 7268
Joined: Mon Apr 18, 2005 10:30 am
Bike: ZRX
State: New South Wales
Location: Kellyville

Re: SYD - Where should i go for servicing

Post by Glen »

I had the 12000 on the 10 done by Mick at Castle Hill Motorcycles. He's very good and doesn't rip you off.
It's really all about standing around drinking Dave's beer.
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
User avatar
MadKaw
Administrator
Administrator
Posts: 9671
Joined: Tue Apr 20, 2004 4:33 pm
Bike: ZX10R
State: New South Wales
Location: Windsor or the Creek..
Contact:

Re: SYD - Where should i go for servicing

Post by MadKaw »

Theres also Glen at All Fix automotive in Castle Hill.
Dave
2010 Z1000
ex bikes
05 ZX-10R Race Bike - No.77
95 ZXR750R M Race Bike - No. 75
98 ZX9R Race Bike - No. 000
zx6r, zx7r, GPX750, GPX500, lots of KX's.
Image
I ride way too fast to worry about cholesterol
User avatar
Glen
VIP MEMBER
VIP MEMBER
Posts: 7268
Joined: Mon Apr 18, 2005 10:30 am
Bike: ZRX
State: New South Wales
Location: Kellyville

Re: SYD - Where should i go for servicing

Post by Glen »

MadKaw wrote:Theres also Glen at All Fix automotive in Castle Hill.
....and he's got a cool name 8)
It's really all about standing around drinking Dave's beer.
2008 ZRX1200 Greeeeen Roadie
2016 KTM Superduke 1290 Oraaaaange
2016 Seadoo RXTX300
Too many toys.......work is getting in the way!!!!
Vukie
KSRC Member
KSRC Member
Posts: 134
Joined: Wed Mar 14, 2007 10:07 pm
Location: Sydney

Re: SYD - Where should i go for servicing

Post by Vukie »

my bike is still in warranty so im looking to take it to kawasaki dealer, can anyone reccomend one of them?

or are they all as bad as eachother, this thread has had 30 views and not one good comment about a factory dealer :roll:
User avatar
Frank
KSRC Contributor
KSRC Contributor
Posts: 1432
Joined: Tue Jun 07, 2005 10:23 pm
Bike: ZX9R
State: New South Wales
Location: Shaggers Ridge, Sydney

Re: SYD - Where should i go for servicing

Post by Frank »

Vukie wrote:my bike is still in warranty so im looking to take it to kawasaki dealer, can anyone reccomend one of them?

or are they all as bad as eachother, this thread has had 30 views and not one good comment about a factory dealer :roll:
You dont need to go to a dealer to keep your warranty, any licenced bike mechanic can service your bike and it wont effect your warranty. The only reason to take it to a dealer (in MY opinion is to try and get any warranty issues sorted), and as long as your as service book is stamped.
I take my bike to Glenn at All Fixed Automotive, he has looked after all of my bikes. The only time I went to a dealer was to get an oil pressure switch replaced under warranty on my ER-5 a couple of years ago.
GO THE BLUES
Life time member of PETA:-
PEOPLE for the EATING of TASTY ANIMALS
Member of SRT
1998 Kawasaki ZX9R Track Bike
2014 Nissan Navara
User avatar
mike-s
Apprentice Post Whore :-)
Apprentice Post Whore :-)
Posts: 6142
Joined: Sat Aug 07, 2004 5:43 am
Bike: Suzuki
State: New South Wales
Location: Arncliffe, Sydney
Contact:

Re: SYD - Where should i go for servicing

Post by mike-s »

hmm, its a shame Narellan is closed, I can't think of anywhere near Campbelltown.

It reminds me, i should get my bike in for a service, it's not had one since before i bought it.... which was uhm, about 18kkm ago. Having said that though, i have been doing the basics (though i admit i havent taken the tank off yet!!!!)
Image
If it hurts, you aren't doing it right.
User avatar
Technik
KSRC Member
KSRC Member
Posts: 123
Joined: Tue Feb 27, 2007 10:16 pm
Bike: Don't have one
State: New South Wales
Location: Melbourne
Contact:

Re: SYD - Where should i go for servicing

Post by Technik »

[quote="Vukie"] this thread has had 30 views and not one good comment about a factory dealer :roll:[/quote]

i know, think i might just head off to flywheel - sounds like they aint as dodgy as other mechanics.
ZXR750
KSRC Regular
KSRC Regular
Posts: 995
Joined: Mon May 22, 2006 10:27 am
Bike: ZXR750
State: New South Wales
Location: Hills District NSW

Re: SYD - Where should i go for servicing

Post by ZXR750 »

I take my bike to Kelens for all its services. My bike is far from new though. It is a 93 ZXR.
Ken the mechanic is also far from new and has shit loads of experience and he always seems to take care with the little things like not scratching the shit out of the paint with tools.
That is a regular problem with alot of mechanics. They are good at what they do but don't take any care for the bike they are working on.
Remember, half the people you know are below average.
Bike 93 ZXR750
05 ZRX1200
05 DRZ400
User avatar
rooster
VIP MEMBER
VIP MEMBER
Posts: 2300
Joined: Mon Mar 21, 2005 7:39 am
Bike: Z1000
State: New South Wales
Location: FULLY FLEDGED SHIRE HOBBITT

Re: SYD - Where should i go for servicing

Post by rooster »

On Two Wheels is now the Kwaka dealer for Campbelltown. Haven't had any dealings with them though. I take my bike to Campbelltown Motorcycles in Blaxland Road good guys, tell them Eric sent you, they also have the dyno there if you want to go the whole hog on getting the bike running properly. :D :D :D :D
If life is like a box of chocolates, why do I always get the laxettes?
Vukie
KSRC Member
KSRC Member
Posts: 134
Joined: Wed Mar 14, 2007 10:07 pm
Location: Sydney

Re: SYD - Where should i go for servicing

Post by Vukie »

Did a quick ring around to a few dealers for the 6 month service on a ZX6R:

Kelen: $200 + parts
Aitkens: $255 + parts
Flywheels: $500 :shock: :shock: - the 10% memebr discount is still $450
User avatar
BikerBoy
KSRC Member
KSRC Member
Posts: 275
Joined: Fri Oct 06, 2006 2:14 pm
Bike: Z1000
State: New South Wales
Location: Australia

Re: SYD - Where should i go for servicing

Post by BikerBoy »

Yea any dealer around central sydney City will be much more expensive than in the outer suburbs...


Check out http://www.budgetbikes.com.au" target="_blank

401 Hume Hwy,
Yagoona 2199 NSW

They did my tuning, major service, shimming etc. Forgot the Guys name but its owned by 2 brothers who
were really genuine and did a great job.

Highly recommend them
ZXR750
KSRC Regular
KSRC Regular
Posts: 995
Joined: Mon May 22, 2006 10:27 am
Bike: ZXR750
State: New South Wales
Location: Hills District NSW

Re: SYD - Where should i go for servicing

Post by ZXR750 »

Vukie wrote:Did a quick ring around to a few dealers for the 6 month service on a ZX6R:

Kelen: $200 + parts
Aitkens: $255 + parts
Flywheels: $500 :shock: :shock: - the 10% memebr discount is still $450

Is the $500 for labour only or does that cover parts also???
Remember, half the people you know are below average.
Bike 93 ZXR750
05 ZRX1200
05 DRZ400
Post Reply