Kawasaki Sportsbike Riders Club - Australia - Online Forum

Unfortunately when a previous owner installed the exhaust they did a poor job and has resulted in burning out components in the servo motor and consequently the sensor circuit tells the ecu there is an issue therefore I either have to replace the whole servo motor (which includes the sensor circuit ...

Be happy to mate ;)
Well I made another one this morning and used some electrical tape and heat shrink instead of the epoxy.....
Plugged it in and switched the ignition on and it worked :kuda:
However.....
I've found out if I turn the ignition on (or turn the bike on as well) within half an hour ...

Thanks for that Rob, yeh I got a diagram (I think it was a link from one of the thread on here to another forum).
Got the parts this arvo for $6-7 :D got home and soldered it up and thought I'd test it before covering in epoxy and it worked perfectly :kuda: , unfortunately when I covered it in epoxy ...

The fuel injection warning light came on my '08 Z750 a little while back and I've had the bike pulled apart in the garage for a while now and think I've worked out what the problem is and what I need.

I've done some research and I think I could actually do nothing and it will be fine however that ...

Im no mechanic and still pretty new to bikes but I would say it's normal, if your still concerned change the oil and filter, then in another 1500km (when it discolours again going off what you have said) you'll be due for the 6000km service

I'm a bit late on this but when I looked on the RTA website sometime in the last year it read as wattie explained
Keen to hear if anything has happened yet tho??

well done mate, happy you passed

4m spacing with a 0.6m offset
not sure what happened to my earlier link :? but this should help;
:-x files too big....
go to http://www.rta.nsw.gov.au
click on the 'license' tab
scroll to the bottom where the box titled "DOWNLOADS" is and click on "license test guides and handbooks'
scroll to the ...

WTF!?!
That's one messed up day :shock:
I'm curious, u said u lost 3 points, then 2 points, then screwed the u turn.....that's 5 points total so u still had 4 more before a failure.....did u go outside the line as well as put your foot down?? otherwise the way I see it u should have passed (you get ...

I just bought a voucher for my advanced open water divers certificate :D if anyone is interested in doing it with me.
I've booked through Prodive (Amber) and will be going from Coogee. As I've bought vouchers the dates are not yet confirmed but will be looking at early next month (June). It cost me ...

Dont stress mate, it'll feel a bit awkward to start with but with a bit of practice it'll be no trouble, just do a little practice. throw some cones (or twigs) out in a quiet place and spend some time on it.

Do you guys have to do the figure eight exercise?

U turns 6m from memory

Figure 8, maybe the cone weave? :?
6.1m actually :)

http://www.rta.nsw.gov.au/licensing/release_information_to_authorised_organisations.html
http://www.wheel-skills.com.au/RTA-motorcycle-operator-skills-test-MOST

i ...

No, what I mean is your body is in a more upright postion (not necessarily bolt upright) - leaning the opposite way to your turn....your body should be leaning in to the corner when your cornering - the direction the bike is leaning. Because you are going at a much slower speed for the u-turn you ...

Throttle control, body position on top of bike (as opposed to cornering), look at where you want to end up (same as cornering), rear brake, clutch and smoooooooth. Practice and feel the bike/manoeuvre

I got a $7k personal loan from a credit union for a new 2fiddy (although I would now advise someone to get a cheaper/second hand bike to begin on) at 9.54% with no penalty for early pay out (they also offer quite reaonable interest rates for savings accounts)