


Sorry to bore you guys but i needed to have a rant about it
Mate i would of loved nothing more than making him eat his on teeth, but i was on duty at work and it wouldnt look very good if the Bar Manager had belted the living pulp out of a patron, but the up side is i found out who is was and where he livesfidler28 wrote:Stuff standing back i would of belted the s&*t out of them you dont touch other peoples property expecially there bike or car
Thanks for the helpNeka79 wrote:assholes deserve a belting..as for rectifying the problem mate, its pretty simple...
wot bike is it ?? if its got a centre stand sit it on that, then get a volunteer to sit there ass on the pillion seat..hence lifting the front...
failing this (no centre stand) jack up the front using a jack or a front end stand...
loosen the top tripple tree just a little bit..not too much or the forks will fall right out...
loosen the lower triple clamp (see above) ..not too much, just enuf that u can "manipulate" the forks back into position...
the bolts should be abt a 12mm nut horizontal to the ground, going into the triple clamp ....
once uve re-aligned them just tighten them up..problem solvered!!
HTH
if u have ne dramas ppm TY , he had a gpx that he did all sorts of work on, if ne1 knows abt em it would be him...i can give generic advice as ive played with the odd gpx/zzr ...87Ninja wrote:Thanks for the helpNeka79 wrote:assholes deserve a belting..as for rectifying the problem mate, its pretty simple...
wot bike is it ?? if its got a centre stand sit it on that, then get a volunteer to sit there ass on the pillion seat..hence lifting the front...
failing this (no centre stand) jack up the front using a jack or a front end stand...
loosen the top tripple tree just a little bit..not too much or the forks will fall right out...
loosen the lower triple clamp (see above) ..not too much, just enuf that u can "manipulate" the forks back into position...
the bolts should be abt a 12mm nut horizontal to the ground, going into the triple clamp ....
once uve re-aligned them just tighten them up..problem solvered!!
HTHand about restraining myself, if i was out of work hrs it would of been a different story