out but not down!!
-
- Warming up
- Posts: 55
- Joined: Mon Dec 31, 2007 9:13 am
- Bike: ZX10R
- State: New South Wales
- Location: bexley
out but not down!!
went for a spin this arvo,cruisin down the old princess hwy,dropped 2 gears to get the revs back up and ,what the!??no gears!the chain broke,luckily didnt wrap around the rear wheel,but managed to break some of the housing in the sump(didnt have a real close inspetion) and dropped all the oil all over the road and rear wheell.again steeped i was going in a straight line so will have a closer look tomorrrow at the damages.it was a fairly old chain but still was in good condition,or so i thought anyway!....
-
- KSRC Member
- Posts: 374
- Joined: Thu Feb 17, 2011 9:32 am
- Bike: ZX6R
- State: Victoria
- Location: Melbourne
Re: out but not down!!
Wowo....very lucky.......
2009 ZX-6r Monster Energy Edition - Hotbodies MGP Growler slipon, DynoJet PCV, Dyno Jet Auto Tune, K&N Race Airfilter
-
- Warming up
- Posts: 55
- Joined: Mon Dec 31, 2007 9:13 am
- Bike: ZX10R
- State: New South Wales
- Location: bexley
Re: out but not down!!
well, stripped damaged parts and sourced a bearing housing which was snapped and front sprocket cover, havent got the cover yet but install the damaged one,now have no speedo but may be fixed when i get the new cover?..as the speedo sensor may be out of line?also took her for a spin today and after about 5k the F.I.light came on!any info on why this happened would be appreciated????
- tim
- VIP MEMBER
- Posts: 5815
- Joined: Wed Dec 10, 2008 10:12 pm
- Bike: ZX6R
- State: New South Wales
- Location: Sydney, NSW
Re: out but not down!!
missed this..... Snapped chain
how do you look after it? How many k's were on it? Awdjudted properly? geez amazing you didn't bin it.....

2008 ZX6R Special Edition
-
- Warming up
- Posts: 55
- Joined: Mon Dec 31, 2007 9:13 am
- Bike: ZX10R
- State: New South Wales
- Location: bexley
Re: out but not down!!
the bike had been idle for a year before i bought it,the chain/sprockets were by no means new but were well lubed and correctly tensioned,I had done about 3k on it with no probs beforehand so dunno why this happened??i did change the front sprocket to 16 tooth(-1)anyway im still in 1 piece so now need to fix fi issues...