Hi blokes,ive stripped the zx down and checked the valve clearances and 8 for them are out of spec.So im up to changing the shims(never done this before )
Any tips or advise from you guys that have done this before?
05 zx 636 valve shims
-
budgienutz
- KSRC Member
- Posts: 170
- Joined: Mon Sep 06, 2010 2:13 pm
- Bike: ZX10R
- State: New South Wales
- Location: Coffs Harbour
05 zx 636 valve shims
Have you ever looked at someone and thought.
"YOU were the load your mother should have swallowed"
"YOU were the load your mother should have swallowed"
-
zxsixr03
- KSRC Regular
- Posts: 896
- Joined: Mon Jan 24, 2005 7:04 pm
- Bike: ZX6R
- State: New South Wales
- Location: Sydney
Re: 05 zx 636 valve shims
Mark them all very clearly in order of where they came from, you might get a away with swapping some etc, most bike shops should also do a swap plus a small amount of cash...
Built by craftsman, Designed by a genius, Ridden by a twat....
-
budgienutz
- KSRC Member
- Posts: 170
- Joined: Mon Sep 06, 2010 2:13 pm
- Bike: ZX10R
- State: New South Wales
- Location: Coffs Harbour
Re: 05 zx 636 valve shims
Well ive just finished putting it back together(got it wrong twice as my markings on the cam and chain came off)
once i settled down and reread the manual until i completely understood what it said(thought i did the first two times) i got it back together
now its smooth as,it was vibrating heaps before and had a really loud rattle.so im happy as larry.
once i settled down and reread the manual until i completely understood what it said(thought i did the first two times) i got it back together
now its smooth as,it was vibrating heaps before and had a really loud rattle.so im happy as larry.
Have you ever looked at someone and thought.
"YOU were the load your mother should have swallowed"
"YOU were the load your mother should have swallowed"