Will bar end weights from a 08-10 ZX10 fit onto 06 ZX10R clip-on's?? I'm asking becasue I am buying a heavier set from the states and all they have at the moment are for 08-10 Zx10. Mainly concerned with the thread pitch and size.
Any help would be much apreciated.
Clip-on bar end weights
-
Mad RS
- KSRC Member
- Posts: 118
- Joined: Sun Oct 25, 2009 12:00 pm
- Bike: ZX10R
- State: Queensland
- Location: Tamborine, QLD
Clip-on bar end weights
Run what ya brung...............make damn sure you brung enough!!!
-
Spaldo
- Newbie
- Posts: 38
- Joined: Fri Jan 07, 2011 7:18 pm
- Bike: ZX10R
- State: Western Australia
- Location: Split time between Pilbara and Perth
Re: Clip-on bar end weights
Let me know how you go mate coz i need some for my ZX10 08 as well !!! and am strugling to find any locally..
If you have it under control you don't have enough Power
-
Mad RS
- KSRC Member
- Posts: 118
- Joined: Sun Oct 25, 2009 12:00 pm
- Bike: ZX10R
- State: Queensland
- Location: Tamborine, QLD
Re: Clip-on bar end weights
http://www.hvmp.com/kawasaki.htm
These are what I am looking at at the moment. They definately have a set for the 08 ZX10R as I was looking to see if they would fit the 06-07. My grips hang about 6mm past the end of my bars. Is this normal or are my grips longer than normal??
These are what I am looking at at the moment. They definately have a set for the 08 ZX10R as I was looking to see if they would fit the 06-07. My grips hang about 6mm past the end of my bars. Is this normal or are my grips longer than normal??
Run what ya brung...............make damn sure you brung enough!!!
-
Spaldo
- Newbie
- Posts: 38
- Joined: Fri Jan 07, 2011 7:18 pm
- Bike: ZX10R
- State: Western Australia
- Location: Split time between Pilbara and Perth
Re: Clip-on bar end weights
mine finnish flush with the end of the bars ,ide suggest they are longer than normal but dont quote me on that...
If you have it under control you don't have enough Power