Power Commanders

For general Technical and Performance Discussions
Post Reply
kwakamad
Warming up
Warming up
Posts: 99
Joined: Wed Apr 15, 2009 11:52 pm
Bike: ZX10R
State: Please Select a State

Power Commanders

Post by kwakamad »

Am interested in fitting a Power Commander 3 to my 05 zx10. Have heard issues about bikes not running correctly and even will not start!! I figured once installed u would expect no dramas. Any info be terrific thanks...
User avatar
zx-10r
KSRC Member
KSRC Member
Posts: 446
Joined: Sat Oct 04, 2008 8:34 pm
Bike: ZX10R
State: New South Wales
Location: North Rocks NSW

Re: Power Commanders

Post by zx-10r »

do you have after market exhaust on the bike?
Let the good times roll.

2007 zx-10R Gallery : http://www.flickr.com/photos/41942460@N ... 052319987/
User avatar
ttc
Team Black
Posts: 2893
Joined: Fri Nov 19, 2004 2:59 pm
Bike: Z1000
State: Queensland
Location: Brisbane

Re: Power Commanders

Post by ttc »

You don't actually have to have a modified bike for it to make a difference, once mapped it will benefit the standard bike, but obviously using it with a pipe/filter will give you the biggest gains. If your bike is modified, I highly recommend it, as modifications change the air/fuel ratio that the standard computer doesn't want to know about (most bikes) and can cause dangerous leaning out, jerkiness atc. If you buy one, please spend the money and have your bike mapped properly, no two bikes are the same and that way you will get the maximum benefit out of it.
It's an electrical item, and being such it can fail, pure and simple. But the percentage is quite low for the quanitity of them out there.
Image
kwakamad
Warming up
Warming up
Posts: 99
Joined: Wed Apr 15, 2009 11:52 pm
Bike: ZX10R
State: Please Select a State

Re: Power Commanders

Post by kwakamad »

zx-10r yes my bike has a akrapovic can, k&n filter. ttc cheers for all that valuable info, been lookin ebay seem to be bout $470 mark. Mob in W.A are around $440. Shop in Newy is a power commander dealer do you reckon be better to purchase one from him and get him to dyno, map it in etc, also what is $$$ we talkin? Just a guess around $700 supply/installed ready to ride away be close? thanks
User avatar
zx-10r
KSRC Member
KSRC Member
Posts: 446
Joined: Sat Oct 04, 2008 8:34 pm
Bike: ZX10R
State: New South Wales
Location: North Rocks NSW

Re: Power Commanders

Post by zx-10r »

ttc wrote:You don't actually have to have a modified bike for it to make a difference, once mapped it will benefit the standard bike, but obviously using it with a pipe/filter will give you the biggest gains. If your bike is modified, I highly recommend it, as modifications change the air/fuel ratio that the standard computer doesn't want to know about (most bikes) and can cause dangerous leaning out, jerkiness atc. If you buy one, please spend the money and have your bike mapped properly, no two bikes are the same and that way you will get the maximum benefit out of it.
It's an electrical item, and being such it can fail, pure and simple. But the percentage is quite low for the quanitity of them out there.
What would a PC do to a stock standard bike? I thought the manufacturer would tune the bike to preform to an optimum with the stock pipe.



I agree definately that you need one for aftermarket exhaust and filter.



map it in etc, also what is $$$ we talkin? Just a guess around $700 supply/installed ready to ride away be close? thanks

PC was 450 and custom map dyno tune was 450 for me. Well worth it, felt alot more torquey all round
Let the good times roll.

2007 zx-10R Gallery : http://www.flickr.com/photos/41942460@N ... 052319987/
User avatar
QuickaKwacka
Warming up
Warming up
Posts: 98
Joined: Fri Nov 11, 2005 10:02 am
Bike: ZZR1100
State: New South Wales
Location: Newcastle NSW

Re: Power Commanders

Post by QuickaKwacka »

kwakamad wrote:zx-10r yes my bike has a akrapovic can, k&n filter. ttc cheers for all that valuable info, been lookin ebay seem to be bout $470 mark. Mob in W.A are around $440. Shop in Newy is a power commander dealer do you reckon be better to purchase one from him and get him to dyno, map it in etc, also what is $$$ we talkin? Just a guess around $700 supply/installed ready to ride away be close? thanks
Well worth the cost IF it is tuned (mapped) properly, I bought one from a dealer in QLD for about $440 when he advertised on this site (I think it was superbike supplies but not 100% sure now) and had Jamie at Bike Care do the dyno thing and gained a shit load of HP along with an improvement of about 50 kilometers per tank of fuel. Cost $250 to have him fit it and do the dyno run. was running a Micron Can and DNA Filters at the time.

In my opinion worth every cent. :kuda:

Regards
RonnieG
LET THE GOOD TIMES ROLL

Regards
RonnieG


Yes I did buy Rusty,s bike, what a ripper
User avatar
ttc
Team Black
Posts: 2893
Joined: Fri Nov 19, 2004 2:59 pm
Bike: Z1000
State: Queensland
Location: Brisbane

Re: Power Commanders

Post by ttc »

zx-10r, it comes down to bikes all being different, the stanard ecu just puts the same amount of fuel in.
Benefits are same as a modified bike.. smoother and slightly more power, just obviously not the same horsepower gains, it's more of a rideability thing :)
Image
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: Power Commanders

Post by Saki »

you dont need to pay someone to install it, they take about 10 minutes, if you dont know what your doing!
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
nicko
KSRC Member
KSRC Member
Posts: 153
Joined: Sat Mar 03, 2007 5:00 pm
Bike: ZX12R
State: Victoria
Location: SE Melb

Re: Power Commanders

Post by nicko »

yeah i just got one for my 12, piece of piss to install 3 plugs and one terminal! all the instructions are on there site also!
Nicko
Im not addicted to cocaine, i just like the smell of it!
04 ZX12R
97 Moto Guzzi 1100 Sports
User avatar
ttc
Team Black
Posts: 2893
Joined: Fri Nov 19, 2004 2:59 pm
Bike: Z1000
State: Queensland
Location: Brisbane

Re: Power Commanders

Post by ttc »

not talking about installing - talking about custom mapping.

A downloaded map will be about 90% right..
Image
kwakamad
Warming up
Warming up
Posts: 99
Joined: Wed Apr 15, 2009 11:52 pm
Bike: ZX10R
State: Please Select a State

Re: Power Commanders

Post by kwakamad »

Cheers for the heads up peoples, QuickaKwaka jamie is who i was talking about good guy and knows he's shit... Oh well get a pc on the 10 soon. :)
Post Reply