Finally my 250R

[Creedy]

is that the Competition Werkes fender eliminator? that looks wicked.

where abouts are you getting your carbon yoshi from? i'm looking for the same one for my 250R and not having much luck. and what will it cost you? if you dont mind me asking?

[fireyrob]

is that the Competition Werkes fender eliminator? that looks wicked.

where abouts are you getting your carbon yoshi from? i'm looking for the same one for my 250R and not having much luck. and what will it cost you? if you dont mind me asking?

Yes for the fender. Looks good but had to cut up the old fender to fit it...

Got the yoshi through my dealer... But if your mechanically minded the cheapest ,and probably at this point, quickest way to get one would be through the US! Not sure of which site but there are a few available. I think the importer in Australia is Matt Mladin? Its a must do mod if your planning on keeping the bike a while.

[drewboy]

Congrats on the new bike! and black, well done.

I have to say the replacement for the old GPX 250 was way overdue, but man was it worth it!! These baby ninjas look awsome! the only thing i could knock is the rear fender, but as you said, it's going so that's good also. They look that good it's almost a shame it's only a 250 . Imagine this bike with the engine and wheels from the ER6. Very well done none the less.

Andrew

[Six Addict]

this bike with the engine from the ER6 would be an absolute weapon... that engine's got over 50kW...

but oh my lord id love to have one with about 40kW... then i could do some serious squid chasing....