Rear Brakes

budgie · Post by **budgie** » Wed Feb 22, 2006 10:22 pm

Nick wrote:If you fancy a quick fang across the bridge one evening to Maroubra i'll be only to happy to help you.PM us if you need my address.

Dude, cheers for the offer. I spoke to a mate today and he told me to take it to his mate. It going to cost a case to install

mattyv74 · Post by **mattyv74** » Wed Feb 22, 2006 10:52 pm

Smitty wrote:

and no anti squeal shim???

cheers[/quote]
Just a smidge of white grease on the BACK of the pads does the job.

HemiDuty · Post by **HemiDuty** » Wed Feb 22, 2006 11:14 pm

Bikes have a rear brake too? :shock:

ty · Post by ty » Thu Feb 23, 2006 5:30 am

Smitty wrote:what bike's this for...???
never done a rear caliper with pins or an R clip on it

and no anti squeal shim???

my 9, and I'm pretty sure the 6, has a holding pin at the back of the caliper that goes through holes in the back of the pads to hold em in place - the Rclip goes through a hole in the pin to hold IT in place.
Dunno what an anti-squeal shim is.
ty

Duane · Post by **Duane** » Thu Feb 23, 2006 6:38 am

im pretty sure the 7 is the same as ty's and my tl was certainly the same

Bionic · Post by **Bionic** » Thu Feb 23, 2006 11:53 am

on my 95 zxr 750 it was very easy.

1. Take off plastic cover on bottom on caliper.
2. look under neith caliper. You should see the 2 pins that are holding the pads in as well as the split pins that hold these pins in.
3. Remove split pins.
4 Slid pins out through the hole on the outside of the calliper.
5. Pads should fall out.

To put new ones in pretty much the exact opposite. AFTER you push the piston back into the caliper a little