To Crim or not to Crim ???

General Discussion
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: To Crim or not to Crim ???

Post by Saki »

I am gunna try score some cheap riding gear!! I am pretty set on it though! So i will suss it out a bit more and take it from there!
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
robracer
VIP MEMBER
VIP MEMBER
Posts: 15251
Joined: Thu Feb 24, 2005 8:23 pm
Bike: ZX6R
State: New South Wales
Location: Port Macquarie

Re: To Crim or not to Crim ???

Post by robracer »

Saki wrote:I am gunna try score some cheap riding gear!! I am pretty set on it though! So i will suss it out a bit more and take it from there!
Work'em hard mate! :lol:
Toby
Warming up
Warming up
Posts: 88
Joined: Thu Jan 31, 2008 2:00 pm
Bike: Suzuki
State: New South Wales
Location: West Ryde Sydney

Re: To Crim or not to Crim ???

Post by Toby »

Didnt the 04 have gearbox issues. I looked into buying a CRIM a while back and was strongly advised by the head mechanic of a kwacka dealership to only buy an 05 model. ;)
The 05 has a completely new gearbox revamped. Alot stronger apparently.
GSXR1000 White K9
User avatar
robracer
VIP MEMBER
VIP MEMBER
Posts: 15251
Joined: Thu Feb 24, 2005 8:23 pm
Bike: ZX6R
State: New South Wales
Location: Port Macquarie

Re: To Crim or not to Crim ???

Post by robracer »

Toby wrote:Didnt the 04 have gearbox issues. I looked into buying a CRIM a while back and was strongly advised by the head mechanic of a kwacka dealership to only buy an 05 model. ;)
The 05 has a completely new gearbox revamped. Alot stronger apparently.
Depends who the head mechanic was & what dealership :lol: there have been a few undesirables the last few years trying to pass themself's off as someone who gives a fark :lol:
User avatar
MickLC
Team Crim
Posts: 5429
Joined: Wed Apr 21, 2004 1:04 pm
Bike: Z1000
State: ACT

Re: To Crim or not to Crim ???

Post by MickLC »

They did make a few changes, but I haven't actually heard of any gearbox's going yet, so who knows. I have remembered one other thing the 04's apparently have an occasional problem with and that's the generator blowing up and distributing frag all around the engine. Happened to a couple of guys in the states but again I don't know of anyone here who had it happen.
'13 Z1000, '76 Z650+,'91 KLR250, '95 ZX6R Racebike
Toby
Warming up
Warming up
Posts: 88
Joined: Thu Jan 31, 2008 2:00 pm
Bike: Suzuki
State: New South Wales
Location: West Ryde Sydney

Re: To Crim or not to Crim ???

Post by Toby »

I agree Rob !!!

But i have since heard this from several well respected mechanics in the industry.

From a technical view, The revamp of the box was apparently that significant, that none of the 04 box internals fit in the 05 !! :shock:

So that does make you wonder why such a large change was required
GSXR1000 White K9
User avatar
ZX-10R_04
KSRC Regular
KSRC Regular
Posts: 762
Joined: Wed Aug 11, 2004 11:18 pm
Bike: ZX10R
State: Tasmania
Location: Launceston Tasmania
Contact:

Re: To Crim or not to Crim ???

Post by ZX-10R_04 »

The 04 didnt have a gearbox issue well mine hasn't :o yeah Saki buy that Crim then ya can buy all the goodies that suits you on the Crim not what the previous owner liked to have on it ... say for instance a cheap crappy pipe when you might wanna have an Akrapovic or some other pipe instead :lol:
If It Aint A Lime It Must Be A Lemon !!!!

04 ZX10R & 08 ZX10R
hoffy
Team Barge
Team Barge
Posts: 8744
Joined: Sun Oct 30, 2005 10:59 am
Bike: Z1000
State: New South Wales

Re: To Crim or not to Crim ???

Post by hoffy »

ZX-10R_04 wrote:you might wanna have an Akrapovic
Its A-Crop-A-Vitch-Farkin' !!!!

:lol:
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: To Crim or not to Crim ???

Post by Saki »

Hmm very interesting about the technical problems.... One thing i did notice about this bike was when slotting the bike from 1st > N there was no resistance and it was uncertain weather the bike had gone from 1st to N even though the N light was on.... But then going back to first it clonked back in... so unsure if this is anything to do with it... as my 9, 636 and even zx2 all had a defined knochy feeling when going from 1st to N, rather than just sliding into N without any resistance....

Sounds a little confusing but anyone else with 04 having this.... What about you malcom ??
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: To Crim or not to Crim ???

Post by Saki »

Well researching and reading more into it, i did come across US forums that were saying that the 04 did have a recall worldwide of 3 bikes in total (04 ZX10R) with a problem with casting issue of hte front wheel. But thats 3 worldwide and all in USA. So they went on to say perhaps there shitty roads etc etc.

Other issue was the Gearbox which was discussed. But no one had said or had anything to prove there was an issue with this and that KHI had held back the release of the 04 ZX10R a few months to fix this issue....

Anyway heard anything further on this.... Dam this bike needs a damper though its pretty nervous in the front!
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
ZX-10R_04
KSRC Regular
KSRC Regular
Posts: 762
Joined: Wed Aug 11, 2004 11:18 pm
Bike: ZX10R
State: Tasmania
Location: Launceston Tasmania
Contact:

Re: To Crim or not to Crim ???

Post by ZX-10R_04 »

Yeah just a little bit notchy going from 1st to Neutral but not too bad after a service with fresh oil & maybe a bit of clutch adjustment ;) I've rode both the Crim & Gumby & really the Crim feels the best as this topic shows :D viewtopic.php?f=28&t=19310
If It Aint A Lime It Must Be A Lemon !!!!

04 ZX10R & 08 ZX10R
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: To Crim or not to Crim ???

Post by Saki »

ZX-10R_04 wrote:Yeah just a little bit notchy going from 1st to Neutral but not too bad after a service with fresh oil & maybe a bit of clutch adjustment ;) I've rode both the Crim & Gumby & really the Crim feels the best as this topic shows :D viewtopic.php?f=28&t=19310
Yeah i have ridden both also and i think the crim feels way better, i think the light crank definately shines! And just the punch of the crim is fantastic!

I reckon crim is prob the way to go! Esp one in very good condition! like this one!
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
Shifty
KSRC Regular
KSRC Regular
Posts: 834
Joined: Tue Apr 26, 2005 9:04 pm
Bike: ZX12R
State: Queensland
Location: Brisbane

Re: To Crim or not to Crim ???

Post by Shifty »

I've ridden an orange 04/05 model and loved it.

The bike pictured definitely needs the rack & pillion seat removed for maximum hotness.
User avatar
Saki
KSRC Contributor
KSRC Contributor
Posts: 2167
Joined: Wed Feb 22, 2006 5:59 pm
Bike: ZX10R
State: Western Australia

Re: To Crim or not to Crim ???

Post by Saki »

Shifty wrote:I've ridden an orange 04/05 model and loved it.

The bike pictured definitely needs the rack & pillion seat removed for maximum hotness.
If i get it, the rack is getting the boot....

As far as seat cowl, will the 06 fit or any other seat cowls of any other models fit of only the cirm made seat cowl, as i dont like the little cushion it has on it!
ZX-2R '88 -> ZX636 '06 -> ZX-9R '99 -> ZX-10R '04 -> Z1000 '03 -> ZX-10R '04 -> ZX-10R '08
User avatar
ZX-10R_04
KSRC Regular
KSRC Regular
Posts: 762
Joined: Wed Aug 11, 2004 11:18 pm
Bike: ZX10R
State: Tasmania
Location: Launceston Tasmania
Contact:

Re: To Crim or not to Crim ???

Post by ZX-10R_04 »

Well either get the holes plastic welded or do this other mod with thin piece of rubber

http://zx-10r.net/forum/showthread.php? ... =seat+cowl
If It Aint A Lime It Must Be A Lemon !!!!

04 ZX10R & 08 ZX10R
Post Reply