rear spools - Ninja 650 & 300

[2Ninjas]

Hi guys,

Just a quick post for those that might be looking to get some rear spools (bobbins) for their ride. I purchased a set for both bikes but found that they didn't fit, turned out the bolts were M10 1.5 pitch and the Ninja 650 & 300 require M10 1.25 pitch. So if you buy a set online or even over the counter make sure you specify the correct thread pitch.

[dickfaber]

if they wont take them back, just go to supercheap (or any hardware) and get the correct bolt - simples

[2Ninjas]

Spools have been sent back, after i spoke with them, they asked me to send both sets back for exchange, all going well should have correct ones by end of the week