Rider Killed by car - Police blame him.!!

General Discussion
ridabike
Newbie
Posts: 2
Joined: Mon May 14, 2012 1:57 pm
Bike: Other Kawi
State: New South Wales

Re: Rider Killed by car - Police blame him.!!

Post by ridabike »

Unfortunately the statics show speeding not to be the top cause of motorcycle crashes but inattention is the top cause :) Therefore all we need to do is pay attention to what we are doing??
User avatar
Gosling1
Team Donut
Team Donut
Posts: 13826
Joined: Mon Jun 20, 2005 9:30 pm
Bike: ZX2R
State: New South Wales
Location: Anarchy Road
Contact:

Re: Rider Killed by car - Police blame him.!!

Post by Gosling1 »

if only it was that easy..... :?
".....shut the gate on this one Maxie......it's the ducks guts !!............."
sandy.singh
Newbie
Posts: 33
Joined: Tue May 15, 2012 4:17 pm
Bike: Honda
State: Western Australia

Re: Rider Killed by car - Police blame him.!!

Post by sandy.singh »

it is very bad news,he is no more, that type of happen increasing day by day .....
User avatar
smithy5
VIP MEMBER
VIP MEMBER
Posts: 3467
Joined: Wed Oct 15, 2008 11:37 am
Bike: Scooter
State: New South Wales
Location: Kurrajong, NSW

Re: Rider Killed by car - Police blame him.!!

Post by smithy5 »

ridabike wrote:Unfortunately the statics show speeding not to be the top cause of motorcycle crashes but inattention is the top cause :) Therefore all we need to do is pay attention to what we are doing??
I saw something similar the other day, I think it was on that Temporary Australian (crap) show on TVS Channel 44. They were doing a low speed rider training segment. The trainer stated that statistics state, more than 50% of Motorcycle accidents, happen at 20kph or less :shock:
2013 Triumph Thunderbird 1700 Storm
Suzuki 1300 LillBusa Ute
Serviced by Allfixed Automotive Castle Hill PH: (02) 9634 1455
SRT Survivor & Oficial Photographer
sandy.singh
Newbie
Posts: 33
Joined: Tue May 15, 2012 4:17 pm
Bike: Honda
State: Western Australia

Re: Rider Killed by car - Police blame him.!!

Post by sandy.singh »

yes you are right smithy. I am agree with you .....
Post Reply