OEM BT016 Tyre life

Kermit · Post by **Kermit** » Mon Mar 26, 2012 10:01 pm

The situation is as follows.

Riding the natio last sunday on my way back, I noted the rear slide on two right handers; I wouldnt call them tight or hair pin corners.

Now there were some damp patches through nation, however I don't recall or believe the two right handers in question were damp.

One right hander was off camber the other wasn't, anywho I am trying to fathom whether my 4500km OEM BT016 rear is gone to shite via joining the HTFU over time, hit some stripage whilst in lean, or its rider error on my behalf.

I am happy to confirm not joining team crash 2012 yet as I kept on throttle and it eventually gripped, is that what backing it in feels like?

Blurr · Post by **Blurr** » Mon Mar 26, 2012 10:40 pm

Whilst I am not saying you had a bit of a slide due to the tyre life but when I was using the bt016 set after set I found the front was toast by 4000kms and the rear not long after but usually it lasted better than the front as the front sides being the soft compound just destroyed themselves by about 3000kms and for the last 1000 it was like riding on a knife edge at half lean. It just constantly fell over and slipped. The rear however was fine, as the bike moving around in the rear was never that bad.

In saying that I thought they were a good tyre .

Kermit · Post by **Kermit** » Mon Mar 26, 2012 10:51 pm

The front sides are looking a lot more worn then the rear, as you mentioned.

On the next run I'll ask a few of the faster guys if they don't mind sitting on the back of me for few corners to see whether its rider error on my behalf.

hoffy · Post by **hoffy** » Mon Mar 26, 2012 11:56 pm

Cant say i see many 16's on the road these days with what available out there..

To me a tyre that wears badly is a bad tyre..No matter how good they are at the start..

Post by **Wattie** » Tue Mar 27, 2012 7:19 am

pics of tyre??????

fireyrob · Post by **fireyrob** » Tue Mar 27, 2012 7:23 am

The OEM's had gone after 2000km's on the zx6 and were sliding. Sticky for a while then were gone. Start a which tyre thread

Phil · Post by **Phil** » Tue Mar 27, 2012 7:30 am

Where is this nation you speak off

Phil · Post by **Phil** » Tue Mar 27, 2012 7:31 am

Might have been one of those rogue twigs from the old road, you know, the ones that got Fitzy, the Fitz or whatever....

holdontight · Post by **holdontight** » Tue Mar 27, 2012 9:27 am

There crap. Get ride ofthem and get new ones. They start to let go before they have worn out thats for sure and you don't get manny ks out of them.
Just my 2c

pittster · Post by **pittster** » Tue Mar 27, 2012 10:34 am

Yeah the OEM 016's are odd with the grip but after a bit of wear and tear mine were average? like cold they were rubbish once they had a few k's on them. Since the OEM's I have had shop bought 016's which were a totally different tyre wore out quicker but stuck like shit to a blanket kinda stuff, now running the 016 Pro's ( updated version) and they also stick to said blanket but only have a couple of hundred k's on them

To summarise once the OEM 016's got 5k+ on them they were average, gave little confidence in the tyre

The non OEM 016's felt great till the very end of life.

Note I am not a pro rider and my feedback is from a novice perspective

Kermit · Post by **Kermit** » Tue Mar 27, 2012 12:26 pm

@ wattie, come along on saturday & check them. I'll bring the camera a long, snap a few of view eating up putty.

@ firey, not opening that can of worms

@ phil, perhaps your antitwig expertutilidge on a run can be imprinted on me.

@ others i'll probably end up ditching them sooner rather than later.

Phil · Post by **Phil** » Tue Mar 27, 2012 12:40 pm

blackster wrote: @ phil, perhaps your antitwig expertutilidge on a run can be imprinted on me.

Only think I'll be able to show you is how to watch your speedo

Post by **Wattie** » Tue Mar 27, 2012 3:20 pm

This is my tyre and why I won't be there...

6maniac · Post by **6maniac** » Tue Mar 27, 2012 4:00 pm

I love your new YELLOW wheels, Wattman ...... but the tyres are all wrinkly ....

Kermit · Post by **Kermit** » Tue Mar 27, 2012 4:05 pm

That's a decent effort! After the supers?

My rear isn't that worn, that leaves rider input.

Kawasaki Sportsbike Riders Club - Australia - Online Forum