zx9r exhaust on z100 - help needed

[z1000-bike]

I bought a 03 z1000, and the guy told me it has a zx9 exhaust on it. The exhaust is too quiet and I want to change it for something else that is a little louder (safer) because I'm sick of getting cut off by blind lazy drivers. I don't want to spend a lot of money on this, as money is currently getting spent of the car for a rebuild.

After searching and asking different shops, I haven't got anywhere and I'm still not sure what will fit on without any changes. It's a zx9 header and muffler with a custom mid pipe. So far I have found this info, but not certain it's what I have.

The 98/99 model use a bolt on can, attached to the headers/mid pipe with a three bolted flange.
I thought the 2000-2003 used a slip on design? Don't the later model (E & F) use an exhaust with a removable mid pipe?

k so what i have discovered is a ZX9 exhaust 00-03 model headers and mid pipe will fit. the 02-03 will fit the best with the most minimal modding. 00-01 a litle more work.

Here are some pics of bike and exhaust

[Nelso]

Just get a slip on to suit a late model ZX9. If you're that worried, measure the diametre of the link pipe outlet to make sure the slip on will fit.

[z1000-bike]

Slip on won't work, mid pipe has the flange welded onto it, and I can't cut it because it's near the bend and won't have any room to lock onto.

[Nelso]

Slip on won't work, mid pipe has the flange welded onto it, and I can't cut it because it's near the bend and won't have any room to lock onto.

That's no good then. In that case if you can't find a cheep slip-on to fit, I would just pick up one of Macca's slip ons http://www.ksrc-au.com/phpBB3/viewtopic ... 17&t=36122 and get a new link pipe made up to fit it to your headers.