Rear stand spools

StuMiller · Post by **StuMiller** » Sun Sep 25, 2011 4:23 pm

I've just swapped the spools over from my 99 ZX6 to my 2007 ZX6 and they appear to go too far through the swingarm and rather close to the chain.

It is a Kaneg rear stand.....should they fit as per the 99 model?

Cheers

smithy5 · Post by **smithy5** » Sun Sep 25, 2011 4:42 pm

PM Pete Kaneg, he should be able to answer your question and he will look after you with new spools if you need them.

Post by **Wattie** » Sun Sep 25, 2011 6:25 pm

Put some washers under the spool so the bolt doesn't go through as far.

StuMiller · Post by **StuMiller** » Sun Sep 25, 2011 8:48 pm

Wattie wrote:Put some washers under the spool so the bolt doesn't go through as far.

I did think of that, but wasn't sure whether should have too.....I was hoping it would be the same as the other setup.

Disco · Post by **Disco** » Sun Sep 25, 2011 8:53 pm

If they are the KANEG spool's they come with an alloy spacer that goe's between the spool and swingarm as the pic below....Maybe your's is missing???

StuMiller · Post by **StuMiller** » Sun Sep 25, 2011 8:57 pm

Disco wrote:If they are the KANEG spool's they come with an alloy spacer that goe's between the spool and swingarm as the pic below....Maybe your's is missing???

Yep, same same. They just seem to screw a long way in.

I might ask Kaneg and double the check bolt width and length are the same....

Kawasaki Sportsbike Riders Club - Australia - Online Forum