License plate installation epic fail

mick_dundee · Post by **mick_dundee** » Fri Apr 15, 2011 5:30 am

laidback · Post by **laidback** » Fri Apr 15, 2011 11:00 am

Hehehehehe...FFS some people should not buy tools...especially a drill...can't do too much damage with a spanner but a drill...

Bogan · Post by **Bogan** » Fri Apr 15, 2011 11:37 am

Pfft people have been doing that for years and that Probetalk forum think they're awesome because people are visiting them.

http://www.ksrc-au.com/phpBB3/viewtopic ... 28&t=21526

http://www.zxforums.com/forums/zx-6r-fo ... -help.html

The more things change the more they stay the same. I want to know what they can do with a torque wrench...

laidback · Post by **laidback** » Fri Apr 15, 2011 11:55 am

Bogan wrote:........ I want to know what they can do with a torque wrench...

That's easy...just use it to do the first stud and find out what's too much then do the rest a bit lower...easy peasy...

Bogan · Post by **Bogan** » Fri Apr 15, 2011 12:00 pm

Do it up until it strips and then back it off a quarter turn yeah?

dutchy · Post by **dutchy** » Fri Apr 15, 2011 12:42 pm

Thats an oldie but a goodie. Someone needs to have a monumental fail and post it up on this forum so we can boost our number of visitors.

Any takers?

Six Addict · Post by **Six Addict** » Fri Apr 15, 2011 5:06 pm

where's firey?

mike-s · Post by **mike-s** » Fri Apr 15, 2011 5:32 pm

First i have to admit I read your post & sig instead of

Six Addict wrote:where's firey?

as

where's firey?

.....
In limbo

But as to the topic, I was going to say, i had a feeling i had seen this earlier, and yeah, i had.

Possum · Post by **Possum** » Fri Apr 15, 2011 7:37 pm

trust you to be looking at probetalk.com

Kawasaki Sportsbike Riders Club - Australia - Online Forum