fireyrob wrote: hmmm hasnt happened yet but that doesnt mean it wont... wait n see I guess.
with the micron & 2 Bros slip on they supplied piece a of alloy to bolt on the top of the servo......all the new cam does is stop on the housing as if there was tension on the cam from the cables...... like I said.... the old ones where like that.
yeah i did this to Red_Raves bike when it was sleeping in my garage. the FI light annoyed shit out of me.
Wattie #55
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455 sam & srt, survived RGM, left a message
EDU wrote:Just to clarify as my English seem to have confused yet another aussie!
What happened was that a friend removed his exhaust and left the cables and servo and after a couple of months the servo jammed and threw a code. He even mentioned something about the bike going into limp mode but I have no idea if that happened or not.
Good to meet you too mate
Ar yes leaving the cables connected will do that! If the cables are removed carefully ensuring the servo doesnt turn then like I said on both bikes I havent had an issue yet. Its 12 months so here's hoping
EDU wrote:Just to clarify as my English seem to have confused yet another aussie!
What happened was that a friend removed his exhaust and left the cables and servo and after a couple of months the servo jammed and threw a code. He even mentioned something about the bike going into limp mode but I have no idea if that happened or not.
Good to meet you too mate
Ar yes leaving the cables connected will do that! If the cables are removed carefully ensuring the servo doesnt turn then like I said on both bikes I havent had an issue yet. Its 12 months so here's hoping
Yeah same with zthou, remove cables carefully without moving cam and it still thinks its working..So no fi light
hmmm hasnt happened yet but that doesnt mean it wont... wait n see I guess.
