ZRX Tail Tidy and Hugger - link for xmas bling bling

[plane]

All I did was hit the rear guard with a stanley knife.

I traced out the line that I wanted to take first, then in I went. Once the initial incision was made, the cutting process was remarkably easy... It ended up looking like the Canadian model's rear guard.



Cheers,
Pete

[Nelso]

That's the same as what mine is like but I added the rego label above the plate. I just realised I need to put the new label in the tube. Sometimes I wonder why I am going to fit the fender eliminator since it looks fine the way it is.

[Phil]

Mine is the same, I did it with Big Guy in the shed with a hacksaw

In the first photo you can see the line marked out, the the second the plate is back on.

BTW, looking at those photos I didnt even recognise my own bike

[Screamin TE]

Nelso, where did you get those indicators? They are the same as what i have on mine but i busted a couple in the off i had.

[Nelso]

From Bikebiz I think. These are them anyway. http://www.bikebiz.com.au/products/Oxfo ... Arrow.html I have the long ones on my bike.

I also bought wiring adapters from this bloke http://cgi.ebay.com.au/Kawasaki-Turn-Si ... 4148f489bc so I didn't have to cut up my wiring.

[Screamin TE]

Cheers for that, ill book mark the site.