ZX7R Engine Stand

[Skullenton Punx]

I'm doing a bit of a clean out today, and have come across the engine stand I made for my ZX7R when I stripped it down. I don't really want to throw it out, but I have no need for it anymore. So for today only it's free to a good home.
I'm going to the tip tomorrow so if anyone would like me to hold it for them, I'm willing to keep it in the garage for a few weeks until further arrangements can be made. Otherwise it will head to the tip in the morning.
Cheers guys.

[Kwakka Kilt]

Skullenton matey !

I always appreciate a job done right, and a home made engine stand would be tops for my 7R

I am located in Sydney, where are you located, I would love to take it off your hands please??

Cheers.
Kilt.

[Skullenton Punx]

I'm located in Ballarat. I don't mind sending it (at your expense though). Another member has pipped you at the post and asked for it 15 minutes earlier. Just wait and see if he is keen still.

On that subject, does anyone know if a 89' model engine uses the same bolt pattern to sit in the frame as a 97' model?

[Skullenton Punx]

Done. Thanks guys. Going to a new home soon.

[Kwakka Kilt]

As long as it goes to a good home ..... Sad to see stuff like that go to the tip