Who sells woodcraft stuff?

MrStompy · Post by **MrStompy** » Sun May 27, 2007 5:56 pm

Anyone know of any online stores in australia that sell Woodcraft motorcycle products.
ie clipons, rear sets?

ZX-10R_04 · Post by **ZX-10R_04** » Sun May 27, 2007 6:47 pm

http://www.mickhone.com.au/

MrStompy · Post by **MrStompy** » Sun May 27, 2007 7:41 pm

thanks for that.
Ive emailed them so hopefully they will get back to me with prices tmw.

Post by **robracer** » Sun May 27, 2007 8:20 pm

Geez you are getting keen on the mods

MrStompy · Post by **MrStompy** » Mon May 28, 2007 8:48 am

yeah im keen on mods but this isnt for my bike.

its for my bros track bike that i maintain for him.
we needs some spares and it has woodcraft stuff on it.
he thinks he is rossi - i think i am burgess.

Post by **robracer** » Mon May 28, 2007 9:03 am

MrStompy wrote:yeah im keen on mods but this isnt for my bike.

its for my bros track bike that i maintain for him.
we needs some spares and it has woodcraft stuff on it.
he thinks he is rossi - i think i am burgess.

Thats for Burgess not Rossi

Post by **MadKaw** » Mon May 28, 2007 9:58 am

If you want the alum tube bars, let me know.
I am thinking of going to Capral to buy some tube to cut down and put end plugs in.
I haven't bothered yet cause you have to but about 6m of the stuff but if others want some we can split the cost.

I already knocked up a set using some stuff I had at home.

To buy a set the best price I found was $40, I'm sure it would be much cheaper to make em myself...

MrStompy · Post by **MrStompy** » Mon May 28, 2007 10:19 am

i just ordered some replacement bars before i read your response but i like the sound of your idea.

i would be keen to get more spares so im happy to throw in if you wanna do that.

what do you use for the end caps?
razor sharp pointed bar ends

Post by **MadKaw** » Mon May 28, 2007 10:45 am

MrStompy wrote:i just ordered some replacement bars before i read your response but i like the sound of your idea.

i would be keen to get more spares so im happy to throw in if you wanna do that.

what do you use for the end caps?
razor sharp pointed bar ends

Yeh I was thinking about those but there a bit exy.

I can get some flat plastic ones for $2 each... I figure there lighter and cheaper so may be a better option than spikey bar ends...

Neka79 · Post by **Neka79** » Mon May 28, 2007 6:47 pm

MrStompy wrote:what do you use for the end caps?
razor sharp pointed bar ends

yea... i reckon theres a site sponsor who could hook u up...