Shop at the other one and get their shopper docket thingies and go to BPScottatron wrote:What about Shell 95RON? Reason I ask is that I am a tight arse and use the shop docket discount thingieshoffy wrote:I run 95 premium, or 98 when Im feeling frisky.
I'd recommend running 95 premium, it may just keep it a little cleaner inside and running good.
Ideal fuel for 2005 GPX250?

-
- Warming up
- Posts: 90
- Joined: Sun Oct 15, 2006 10:21 pm
- Location: Reservoir, Melbourne
- Burky
- VIP MEMBER
- Posts: 1646
- Joined: Fri Apr 14, 2006 12:20 am
- Bike: ZX10R
- State: New South Wales
- Location: NSW Padstow
I found the Caltex 98 ultimate premium to be good and did notice it to be smother, as for the cost well it dosn't get ridden as much as it should so it never worried me.
Neka you are right Deisel is a lot harder to start but LPG is worse
Neka you are right Deisel is a lot harder to start but LPG is worse

"I live in my own little world. But it's OK. They know me here"
yep go the standard unleaded unless theres a sticker on your tank saying use 95ron fuel, I use mobile pulp first followed by bp or vortex which is the caltex stuff and give the opticrap a miss although i did get a tank of it once and the bike ran ok on it.
My bike is fuel injected and hopefully still high compression.
Would be wasting your money on the dear stuff on a 2fiddy.
My bike is fuel injected and hopefully still high compression.

Would be wasting your money on the dear stuff on a 2fiddy.
If I rode my bike at the speed of light, what would happen when I switched on its headlights?


-
- Warming up
- Posts: 90
- Joined: Sun Oct 15, 2006 10:21 pm
- Location: Reservoir, Melbourne
- mohawk miss
- VIP MEMBER
- Posts: 1202
- Joined: Thu Feb 23, 2006 2:30 pm
- Bike: ZZR600
- State: New South Wales
- Location: Beyond Woop Woop
- mohawk miss
- VIP MEMBER
- Posts: 1202
- Joined: Thu Feb 23, 2006 2:30 pm
- Bike: ZZR600
- State: New South Wales
- Location: Beyond Woop Woop
I use ULP all the time, no problem, it runs better and better efficiency as the clock ticks.
before 6000 service it hits reserve at around 250km or something, can't remember and i wasn't sure if i fill it up to neck all the time. After that it hits reserve about 275km for a while
now it is getting 320km i still not yet switch to reserve, recently i fill it up full though, and my riding style is quite gentle.
before 6000 service it hits reserve at around 250km or something, can't remember and i wasn't sure if i fill it up to neck all the time. After that it hits reserve about 275km for a while
now it is getting 320km i still not yet switch to reserve, recently i fill it up full though, and my riding style is quite gentle.


- Gosling1
- Team Donut
- Posts: 13823
- Joined: Mon Jun 20, 2005 9:30 pm
- Bike: Z900
- State: ACT
- Location: Anarchy Road
burkys_ninja wrote:I ran the Mower on Caltex Vortex and it grenaded.....







bloody hell, it felt like it could cut through the fence




".....shut the gate on this one Maxie......it's the ducks guts !!............."
- bNiNja
- Newbie
- Posts: 21
- Joined: Sun Apr 29, 2007 10:22 am
- Bike: ZRX
- State: New South Wales
- Location: Newtown, Sydney
So what is the general consensus about the best fuel for a GPX250?
I have a 1988 model which was complianced in 1995 and just had a engine rebuild (about 1500km since rebuild).
I was originally filling her up with the most expensive fuel (i.e. Shell V-Power) because I thought that was the best thing to do. However, I searched and found this thread and now I feel like an idiot for doing that.
So many different opinions, it is hard to decide. I am now filling with (what I think is known as) 95RON. It is the middle priced unleaded at Mobil. I am going to install a bike computer so I know exactly what mileage I am getting on what fuels to work out the most efficient.
However, if it works out that the regular unleaded 91RON has the best efficiency, should I run my bike with that and not worry about engine wear etc? I read on the ninfaq that any fuel above 87 is fine. Anything more is just wasting your money. However, I care more about engine wear than bang-for-buck fuel efficiency.
P.S. what is RON? What is the number? Is it the % of how pure the fuel is or something like that? Why is v-power bad?
I have a 1988 model which was complianced in 1995 and just had a engine rebuild (about 1500km since rebuild).
I was originally filling her up with the most expensive fuel (i.e. Shell V-Power) because I thought that was the best thing to do. However, I searched and found this thread and now I feel like an idiot for doing that.
So many different opinions, it is hard to decide. I am now filling with (what I think is known as) 95RON. It is the middle priced unleaded at Mobil. I am going to install a bike computer so I know exactly what mileage I am getting on what fuels to work out the most efficient.
However, if it works out that the regular unleaded 91RON has the best efficiency, should I run my bike with that and not worry about engine wear etc? I read on the ninfaq that any fuel above 87 is fine. Anything more is just wasting your money. However, I care more about engine wear than bang-for-buck fuel efficiency.
P.S. what is RON? What is the number? Is it the % of how pure the fuel is or something like that? Why is v-power bad?
1988 GPX 250 (1995 Complianced Japanese import)