Number Plate Frames are nearly all gone!!!

ZZRCHIKKY · Post by **ZZRCHIKKY** » Sun Jun 25, 2006 8:14 pm

z900/zx9 wrote:Take your helmet off before trying to fit them or lift u your tinted visor so u can see,or better still stop the bike its easier if the bike is stationary

ur very funny

mohawk miss · Post by **mohawk miss** » Mon Jun 26, 2006 11:01 am

I have to admit that I spent ages trying to get the frame over my plate (new! so I was trying not to scratch it)

In the end I cut the top tab off, the screws hold it firmly anyway.

ZZRCHIKKY · Post by **ZZRCHIKKY** » Mon Jun 26, 2006 1:21 pm

mohawk miss wrote:I have to admit that I spent ages trying to get the frame over my plate (new! so I was trying not to scratch it)

In the end I cut the top tab off, the screws hold it firmly anyway.

thats what my mummy said to try lol he he

Post by **robracer** » Fri Jun 30, 2006 11:56 am

Glen
could you find out from your supplier if they do a different size holder for NSW plates? This is a refrence for the next batch that might get done.
The mould they used for these ones is not much chop as the clips do not allow for a plate of this size... it may be that when the first made the mould the plates made were smaller back then but I have been to the RTA & measured both types of plate available in NSW & they dont fit (without modification of the holder)
Are these manufactured in QLD as per the back? it might be that QLD plates are a different size.
Anyway would be interesting to know

Glen · Post by **Glen** » Fri Jun 30, 2006 1:19 pm

robracer wrote:Glen
could you find out from your supplier if they do a different size holder for NSW plates? This is a refrence for the next batch that might get done.
The mould they used for these ones is not much chop as the clips do not allow for a plate of this size... it may be that when the first made the mould the plates made were smaller back then but I have been to the RTA & measured both types of plate available in NSW & they dont fit (without modification of the holder)
Are these manufactured in QLD as per the back? it might be that QLD plates are a different size.
Anyway would be interesting to know

We had a thread going before ordering on what size each state's plates were and there are subtle differences. This is why I put the dimensions that the covers fit on the front page. He only does one size so we couldn't tailor them per state. They do fit NSW plates though, albeit with a little coaxing. As I mentioned on the front they're a tad small in terms of height and therefore the top bows upwards a little.

Cheers

Post by **robracer** » Fri Jun 30, 2006 1:27 pm

Thanks for that Glen