Kawasaki Sportsbike Riders Club - Australia - Online Forum

Yeah thats where i ended up getting them

Cheers

im after a set of float needles for my 1991 zxr 250 C model

but im having trouble finding some so my question is will any other models fit like a zzr 250.

cheers

Wow you guys can certainly crap on.
Look at my original post all i wanted to know was the float height???

Just received the manual and it says between 9 and 13mm

Can somebody tell me what the float height is for a 1996 ZZR 600

Thankyou

Just wondering if anybody has a service manual i could grab

Also i have a 11/96 ZZR 600 and i think its called an E model what years does the E clasification cover,

Thanks

Thanks mate
Yeah when i took the carbys apart 2 of the float needles had approx .5mm gap between the aluminium and the base of the viton tip the actual sealing face of them looks good and they were still attached

Yeah i really dont think its the Exhaust valves the biuke was running fine last time it was rode its been sitting for about 10 months

Yeah i cleaned the carbys good and made sure all those components were clear and reset the float levels plus ive put a plug on the end of each lead and it was firing good.

One thing i did notice was the rubber seat on the end of the float needle was slightly detatched between the rubber and ...

Hi
Ive just purchased a ZZR 600 1996 model

When i got it the bike wasn't running smooth and wouldn't idle.
Ive pulled the carby's apart and fully cleaned them and also replaced the plugs but it still runs rough, all the cylinders are firing but it sounds like the timing is out?? is this possible ...

ive put gasket sealer on them this time but it wasn't leaking from there

Just soaked the parts in white vinigar over night.

It worked eveything is clean again

Thanks

Anybody know the float height for a 1991 ZXR 250 C model

Cheers

Thanks guys

Are you talking about the o ring that sits under the front of the tap?

As for the Carby cleaner it didn't remove shit!!
This stuff was baked on like a overcooked pork roast i tried soaking the components in everything nothing broke it down