


clay wrote:Just been reading the manual. According to it, the break in period should be observed as follows:
0-800kms rpm not to exceed 4K
800-1600kms rpm not to exceed 6K
I picked up the bike today with 1100kms already done on it and I had the revs as high as 10K, sitting on 9K for about 40mins while on the motorway. And often was over 6,000rpm.
Could I have possibly done damage? The dealer told me I could ride it as hard or as slow as I liked, it was already broken in...
Saki wrote:Simple answer..... No damage will be done
Dealer is correct
The most part of the run in stage is within the first few hundred km's. Just ride it normally, the run in oil would have been dropped and most likely replaced with a mineral based oil till around 5,000k's now its more to letting the gearbox run in as that can take between 5-10,000k's depending on how you treat it and then its fully done, Fully sick
ijuschill wrote:Sweet stuff there Clay, the green is the best colour on the 2fiddy
Yellow looks cool too.
Return to Show Off Your Ride & Photo Comp
Users browsing this forum: No registered users and 1 guest