valve clearences on ZZR250

[hoon]

Hi all,

My ZZR 250 was donw to 80 psi in the left cylinder. Turns out there is no clearnce between the rocker and trhe valve Time to reset the clearences,


Its a 2001 ZZR 250. does anyone know what the correct valve clearences are ?

sorry if this has been asked before but nothing came up in seach.

thanks

[mike-s]

from memory the intake should be 0.08mm (0.06-0.1 being the acceptable range) and exhaust 0.12mm (0.10 to 0.15mm)

[Gnome]

Inlet 0.08~0.13mm
Exhaust 0.11~0.16mm

From the official Kwaka ZZR service manual

[mike-s]

shoot, i wasnt totally right, but i was close

[Gnome]

You were that close from memory. I wish my memory was that good, both of your solid stats were inside tolerence . I'm a ZZR250 nut and I had to look it up.

[mike-s]

helps to have done clearances more than a handfull of times