Page 1 of 2
99 zx9r - Does this look right?
Posted: Fri Aug 22, 2014 12:04 pm
by 98ninja
So I started stripping the bike down in May 2012. Long story short, it ended up at a mates place and I got it back in bits a few weeks ago.
I have a Haynes manual but it doesn't seem to help, so is everything in the picture in its correct place?
Re: 99 zx9r - Does this look right?
Posted: Fri Aug 22, 2014 1:10 pm
by QQQ
Nothing is standing out as completely out of place. As long as the airbox goes on without fouling I'd say ur good to go.
Re: 99 zx9r - Does this look right?
Posted: Sun Aug 24, 2014 3:48 pm
by z3149441
Looks ok from here, with the exception of the ram air tubes a little to far over the motor. I can PM you some pictures out of the Kawasaki manual if you think that may help?
Re: 99 zx9r - Does this look right?
Posted: Sun Aug 24, 2014 5:53 pm
by MadKaw
Get rid of the KLEEN stuff.
Re: 99 zx9r - Does this look right?
Posted: Mon Aug 25, 2014 6:32 am
by paulsj
Does getting rid of the Kleen stuff do much? Been thinking about that for my one? You mean buying the blanking plates for top of the rocker covers and removing the plumbing??
Re: 99 zx9r - Does this look right?
Posted: Mon Aug 25, 2014 7:37 am
by MadKaw
Doesn't add any hp but reduces the backfire and popping on decel and makes it easier to tune air fuel ratios.
You don't need block off plates, just put a connector or a hose between the outlets in the plates in there and block the hole in the air box..
Re: 99 zx9r - Does this look right?
Posted: Mon Aug 25, 2014 10:32 am
by 98ninja
z3149441 wrote:Looks ok from here, with the exception of the ram air tubes a little to far over the motor. I can PM you some pictures out of the Kawasaki manual if you think that may help?
That'd be great thank you. I think I've got the tubes in backwards.
I'm off to bunnings to get some 16mm copper tubing to connect the kleen tunes together.
Re: 99 zx9r - Does this look right?
Posted: Mon Aug 25, 2014 12:28 pm
by 98ninja
Also any idea where this house plugs into?
It connects at the back of the carburetors right I'm the middle
Re: 99 zx9r - Does this look right?
Posted: Tue Aug 26, 2014 8:52 pm
by shadowzx9
Back of the carbs?
might want to have a look, looks like the line from the Radiator to the back of the barrels
Re: 99 zx9r - Does this look right?
Posted: Tue Aug 26, 2014 9:26 pm
by MadKaw
Isn't that the one that goes into air intakes in the front fairing.?
If so it pressurizes the float bowl
Re: 99 zx9r - Does this look right?
Posted: Wed Aug 27, 2014 9:59 am
by QQQ
Looks like the line to the radiator.
Re: 99 zx9r - Does this look right?
Posted: Thu Sep 11, 2014 6:58 pm
by z3149441
goes to the radiator. Think that its the one that connects just below the radiator cap.
Re: 99 zx9r - Does this look right?
Posted: Wed Sep 17, 2014 6:20 pm
by Strika
Carb heater hoses I think from my drug fucked memory.......
Re: 99 zx9r - Does this look right?
Posted: Tue Sep 23, 2014 1:00 pm
by 98ninja
Ok next question. The thing in the photo. It's meant to go on the rear engine bolt above where the sprocket is. Does it serve a purpose? Because it's a caaaarnt to fit
Re: 99 zx9r - Does this look right?
Posted: Tue Sep 23, 2014 1:09 pm
by shadowzx9
Its a spacer, you dont want to be leaving that off
