Page 1 of 1
ZX14 PCV or TRE
Posted: Sun Oct 31, 2010 11:56 am
by zx14ninja
Hey guys!
If i am getting a PCV fitted an DynoTuning my ZX14 is it necessary to fit a TRE to the bike?
Cheers
Re: ZX14 PCV or TRE
Posted: Sun Oct 31, 2010 4:30 pm
by Dingus
not necessary at all, but if you plan on getting a TRE down the track I would put it on before getting the PCV mapped.
Re: ZX14 PCV or TRE
Posted: Sun Oct 31, 2010 6:25 pm
by seiko1
TRE is pretty bloody useless anyway
Re: ZX14 PCV or TRE
Posted: Sun Oct 31, 2010 7:41 pm
by Dingus
agreed, I still don't know if mine even does anything at all. The only reason it's still on my bike is because it is spliced into an ECU wire (healtech XTRE).
Someone on the zx-10r.net forums smashed an ivans performance one open and all it was was a 10ohm resistor in an epoxy tube with a connector on the end
Re: ZX14 PCV or TRE
Posted: Mon Nov 01, 2010 11:58 am
by seiko1
Dingus wrote:agreed, I still don't know if mine even does anything at all. The only reason it's still on my bike is because it is spliced into an ECU wire (healtech XTRE).
Someone on the zx-10r.net forums smashed an ivans performance one open and all it was was a 10ohm resistor in an epoxy tube with a connector on the end
I get a liitle more down low but a lot less up high
I just don't use it anymore