Kawasaki Sportsbike Riders Club - Australia - Online Forum

Alomst ready to get on the road!

Cheers
Wilbo

Hey guys,

Just wounding if anyone can help me out with after market part numbers for an oil filter for my ZX6R (02, 636). I'm guessing / hoping that there is something one can buy from the likes of repco / super cheap as opposed to forking out for genuine?

Also I'm in the market for a replacement ...

Gee I have a messy shed :S

This was my plan for mounting the light / indicators.
http://i224.photobucket.com/albums/dd108/wilbo666/tn_DSC03862.jpg

And this was my float bowl pressurization setup. I t'd into the crankcase ventilation and used the stock filter as the T piece. I figure it isn't ...

Well I've slowly made some progress.

I'm happy with just the rubber air ram tubes sticking through the frame now! I ran a strip of foam tape (~15mm x 2mm?) around the rubber ram air tubes a few mm from the other edge of the frame where the go through. That has taken up the slack that was there ...

On my 9R those tubes just hang out in the air and they're fine, they're so light they're not going to get up to any mischief. I'll eventually cut them down a bit because they don't have to be so long.

Make no mistake though, streetfighter isn't a cheap way to go. Once the headlight's out of the ...

Some good ideas coming through :)

While I like the idea of the streetfighter, I will continue to try and find the fairings I need...I was thinking that if I can make the fightering cost pretty well nothing (so far I need a headlight and that is it pretty well), then I can be as patient as I like ...

I'm going to go down the path of making the ZX6R naked (Not having a lot of joy finding fairings, let alone at reasonable prices!)...

Most of it is pretty straight forward as far as I see it...

I'm going to use a single 5 3/4" headlight (make a bracket up that goes from the frame where the ...