Building your own motorbike work bench?

[BrisZX9R]

Does anyone have the plans available that they are willing to share on how to build your own hydraulic or pneumatic operated work bench??

I want to build my own, unless it's cheaper and easier to buy one.

Can anyone help me out?

Thanks.

[mike-s]

firstly, how are your welding skills?

[BrisZX9R]

arc welding.. poor (could do it to save my self that's about it)

mig (which I own - gasless) not too bad. I can get a good bead.

I figured there would be lost of cutting, welding, grinding and painting.

[Sulli]

http://www.chansen.net/Members/VMAX/Mot ... 132006.pdf

[Rossi]

How often would it get used ?

The following idea from another forum I frequent was to put the bike up on Front & Rear stands and build one slightly below it

Picture029.jpg (61.81 KiB) Viewed 1865 times

[Rossi]

A closer look at a good idea

Picture034.jpg (51.14 KiB) Viewed 1861 times

[Gosling1]

.... it's cheaper and easier to buy one......

there is your answer right there mate

[BrisZX9R]

thanks Gos... thought it might be...

[IsleofNinja]

The Molnar single phase belly lift works very well but that's just showing off I guess