Renovations I don't remember ordering!

[seiko1]

It's hard to believe the tennants etc didn't go and look - sucks!

They said they were scared, but whats wrong with the phone?

[photomike666]

If they happened to leave a PS2 lazer behind I might be interested - it seems almost cheaper to buy a new PS2 that repair the one I have

[seiko1]

CAVERN IMPORTS Darryl PH 0352210551
Geelong Guy we use at Mr Rental for out of warranty stuff.
Tell him Steve at Mr Rental told you to ring
He's bodgy as and can get anything but PS3 Lasers to work (keyed to machine)

[myk1979]

Am i the only one who's impressed at how that sheet of glass held up to the beating? Paid for itself!

[mike-s]

It would have paid for itself if the freaking security/coppers/tennants pulled their fingers out and did something about it. Given how determined the guy was about getting in and how long he was in there for they (the cops) could have nabbed him.

I mean ffs, if i ever considered doing something as brazen (or stupid) as that, there is NO WAY i would be faffing about for 20 minutes like this guy is supposed to have done. If i couldnt get in within a minute or two (and get the stuff i was after in a further 2-3 minutes, tops) then i would give up and gtfo. The longer the time between leaving the premises and the cops arriving on-scene, the better it is for me.

[tim]

I mean ffs, if i ever considered doing something as brazen (or stupid) as that, there is NO WAY i would be faffing about for 20 minutes like this guy is supposed to have done. If i couldnt get in within a minute or two (and get the stuff i was after in a further 2-3 minutes, tops) then i would give up and gtfo. The longer the time between leaving the premises and the cops arriving on-scene, the better it is for me.

So what did you get away with mike?

[seiko1]

Am i the only one who's impressed at how that sheet of glass held up to the beating? Paid for itself!

It's 8.38 Clear Lam but with a 440 Dollar stick on Plastic coating.
Good stuff, but unfortunately the glass is not in the Galzing channel at the bottom because some bright spark installed the frame
with the glazing bead on the outside (tiled now!)
It just has that pissy little 15x15x1.6 angle holding it in and it didn't hold for long.
40 x 40 x 3 will replace that.