Page 1 of 1
zx636r oil filter size
Posted: Fri May 19, 2006 11:49 am
by hidepenny
anyone knows???? as i'm buying or thinking to buy , will it fit???
http://cgi.ebay.com.au/OIL-FILTER-RATCH ... dZViewItem
Posted: Fri May 19, 2006 11:50 am
by hidepenny
well priced too????
Posted: Fri May 19, 2006 5:15 pm
by Stretchy
That is the one i was trying to say in your other thread, it works great.
Yes it should fit, the claw opens up as you turn it so it works both directions.
Posted: Fri May 19, 2006 9:24 pm
by Barrabob
The 636 has a retasining clip on the oil filter hidepenny make sure you take that off first and i fitted most of my oilfilters so i can get them off easy too but if i get a tough one I just punch a hole through it with a phillips head screwdriver and use that as a handlle, works a treat.
Posted: Fri May 19, 2006 9:29 pm
by Minorci
Just need to make sure you have plenty of rag underneath cause it pisses out everywhere
I used that trick when i got the factory filter off
Posted: Tue May 23, 2006 11:51 pm
by mitch179
bob is right about the philips head trick! cheaper than buying the tool
i found mine came off easy ... just used my hand! just remember u dont have to do them up super duper tight, just screw it on .. then give it a nip sorta thing to secure it ..
Posted: Wed May 24, 2006 7:46 am
by sluglie
just use k&n oil filters, they have a 19mm nut on top so all you ever need is a spanner (which i am sure you have somewhere)