Page 1 of 1
Chain & Sprockets
Posted: Mon Apr 24, 2006 11:22 am
by diesel
decided i wanna go a tooth down on the front sprocket.
i also want this done ready for halls gap.
anyone that can tell me where in melbourne i'd be able to get these parts today or tomorrow that'd be great.
i only want steel sprockets and an x-ring chain, nothin special req.
p.s. bit of info,
bike is a 95 zx9r, B2 model.
front sprocket will be a 15 tooth
rear a 44 tooth.
standard chain length is 112.
Posted: Mon Apr 24, 2006 11:36 am
by Duane
PS's should have that kinda stuff
cosways, anywhere
Posted: Mon Apr 24, 2006 11:37 am
by Stereo
It will probably have to be a kwaka dealer... give the guys in town a call....
Posted: Mon Apr 24, 2006 12:57 pm
by diesel
Posted: Mon Apr 24, 2006 1:01 pm
by Felix
Hope you have some kind of impact driver to get that front sprocket nut off...either that or a large ball pein (1.5lb or bigger) and a brass drift...
Provide your own swear words...
Posted: Mon Apr 24, 2006 1:08 pm
by Stereo
diesel wrote:All sorted, peter stevens was the way to go.
also picked up a chain breaker and riveter for $85
I tried to get some from Peter Stealers when i was looking for them, but they are no longer a Kwaka dealer, so didnt have the bits I needed... Apparently older models had the same configuration as other bikes, but the 03 onwards models didnt
Posted: Mon Apr 24, 2006 1:25 pm
by diesel
Felix wrote:Hope you have some kind of impact driver to get that front sprocket nut off...either that or a large ball pein (1.5lb or bigger) and a brass drift...
Provide your own swear words...
nup....
but hopefully rossi does
Posted: Mon Apr 24, 2006 8:39 pm
by mrmina
mate peter stevens has most things. they're really good even tho they aren't a kwaka dealer.
actaully they are better than some kwaka dealers
Posted: Mon Apr 24, 2006 8:46 pm
by Phil
Felix wrote:Provide your own swear words...
i have a full catalogue if you need to look at it
