Page 1 of 1
Any dyno graph readers?
Posted: Tue May 13, 2014 8:32 pm
by mrh22a
Hi folks
Just got my bike dyno'd can any one elaborate how i went
bike-2013 zx6r
mods-racefit slip on stock headers ,bmc air filter, smog plates ,pc5
thanks
Re: Any dyno graph readers?
Posted: Tue May 13, 2014 10:31 pm
by tim
Re: Any dyno graph readers?
Posted: Wed May 14, 2014 1:38 am
by Kermit
6.7 hp gain from stock?
You can't compare different dyno's, below is a reference point for stock bikes; 600 vs 636.
Re: Any dyno graph readers?
Posted: Wed May 14, 2014 1:54 am
by mrh22a
yeah every dyno varys what i meant was the curves etc who can tell me if there ok or needs improvement so i can bring it back
Re: Any dyno graph readers?
Posted: Wed May 14, 2014 10:37 am
by Kermit
mrh22a wrote:yeah every dyno varys what i meant was the curves etc who can tell me if there ok or needs improvement so i can bring it back
Your bum dyno & the AFR (air fuel ratio) will tell you whether power deliver is smooth.
Does it feel smooth on light loads or just WOT (wide open throttle)?
Did you get a copy of the air fuel ratio (AFR) ?
If the AFR is tuned too rich or lean or if there are lean or rich spikes throughout the power band, it will affect power/delivery.
Are you looking for more power, ditching the CAT will give you a few extra ponies; make use of that PC5.