Kawasaki Sportsbike Riders Club - Australia - Online Forum

Hi guys,

Just a quick post for those that might be looking to get some rear spools (bobbins) for their ride. I purchased a set for both bikes but found that they didn't fit, turned out the bolts were M10 1.5 pitch and the Ninja 650 & 300 require M10 1.25 pitch. So if you buy a set online or even over the counter make sure you specify the correct thread pitch.

if they wont take them back, just go to supercheap (or any hardware) and get the correct bolt - simples

Spools have been sent back, after i spoke with them, they asked me to send both sets back for exchange, all going well should have correct ones by end of the week