Removing ZX7R swingarm bearings?
Posted: Sun Oct 14, 2012 8:08 am
Does anybody here have any experience removing swingarm bearings from a ZX7R?
Problem that I see is that they cannot be pressed out from the other end as the section of the pivot shaft between the bearings is of a smaller diameter than the ID of the bearings themselves.
Must be some trick to it...... any help appreciated!
Jason
Problem that I see is that they cannot be pressed out from the other end as the section of the pivot shaft between the bearings is of a smaller diameter than the ID of the bearings themselves.
Must be some trick to it...... any help appreciated!
Jason