Page 1 of 1
Risers for my ZX1000SX Ninja
Posted: Tue Dec 20, 2011 10:54 am
by SNAFU
Hi for anyone interested I had a set of risers made for my ZX1000SX Ninja. No one makes a set of them yet so I drew up a design and took it to young bloke who made these. They are a bit chunky but raised the bars up 10 mil and swung them forward 10 degrees. I didn't have to replace any throttle lines or clutch or brake cables and so far they work a treat.
Cya Dutchy
Re: Risers for my ZX1000SX Ninja
Posted: Fri Dec 30, 2011 10:34 pm
by shadowzx9
Wonder if that would stop the kill switch being hit on full right with the bagster on......
Owmuchwassit?
Re: Risers for my ZX1000SX Ninja
Posted: Fri Dec 30, 2011 10:50 pm
by hoffy
whats that switch ? a rocket launcher?
Re: Risers for my ZX1000SX Ninja
Posted: Sat Dec 31, 2011 1:20 am
by swearbear9r
Lmao............
Re: Risers for my ZX1000SX Ninja
Posted: Sat Dec 31, 2011 6:55 am
by SNAFU
Nah!
Mate heat grips, I am going to change it for a smaller one soon. The Bagster doesn't affect the kill switch. Total cost for the risers with powder coating $310.
Cya Dutchy
