Page 1 of 1
Rear stand spools
Posted: Sun Sep 25, 2011 4:23 pm
by StuMiller
I've just swapped the spools over from my 99 ZX6 to my 2007 ZX6 and they appear to go too far through the swingarm and rather close to the chain.
It is a Kaneg rear stand.....should they fit as per the 99 model?
Cheers
Re: Rear stand spools
Posted: Sun Sep 25, 2011 4:42 pm
by smithy5
PM Pete Kaneg, he should be able to answer your question and he will look after you with new spools if you need them.
Rear stand spools
Posted: Sun Sep 25, 2011 6:25 pm
by Wattie
Put some washers under the spool so the bolt doesn't go through as far.
Re: Rear stand spools
Posted: Sun Sep 25, 2011 8:48 pm
by StuMiller
Wattie wrote:Put some washers under the spool so the bolt doesn't go through as far.
I did think of that, but wasn't sure whether should have too.....I was hoping it would be the same as the other setup.
Re: Rear stand spools
Posted: Sun Sep 25, 2011 8:53 pm
by Disco
If they are the KANEG spool's they come with an alloy spacer that goe's between the spool and swingarm as the pic below....Maybe your's is missing???
Re: Rear stand spools
Posted: Sun Sep 25, 2011 8:57 pm
by StuMiller
Disco wrote:If they are the KANEG spool's they come with an alloy spacer that goe's between the spool and swingarm as the pic below....Maybe your's is missing???
Yep, same same. They just seem to screw a long way in.
I might ask Kaneg and double the check bolt width and length are the same....