Page 1 of 1
US ECU into Aus ZX636 05/06
Posted: Sun Aug 08, 2010 11:03 pm
by Steptoe
I'm after info on the wiring mods to put the US ECU into the Australian Wiring Harness on a ZX636 05/06. I had the info some time ago but have since misplaced it. From memory one pin needed to be grounded and another pulled up to 12V (switched?). Anyone help?
Re: US ECU into Aus ZX636 05/06
Posted: Tue Aug 10, 2010 12:03 pm
by zxsixr03
Jump on kawiforums.com biggest Kawasaki community around, they will have the answer...
Re: US ECU into Aus ZX636 05/06
Posted: Wed Aug 11, 2010 3:46 am
by Steptoe
Pretty sure I discussed with someone on here a while back. No bother as have just sourced a US wiring harness too.
Re: US ECU into Aus ZX636 05/06
Posted: Sun Aug 15, 2010 5:52 pm
by cloudnine9
don't know why you would want to do this as thw US ecu will cut you hp by 5-8hp
watched a guy do the mod on you tube to bridge the ecu to get the eruo/asian map thats in the ecu allready.
used gitar wire.
cloud 9
Re: US ECU into Aus ZX636 05/06
Posted: Sun Aug 15, 2010 8:34 pm
by Steptoe
cloudnine9 wrote:don't know why you would want to do this as thw US ecu will cut you hp by 5-8hp
watched a guy do the mod on you tube to bridge the ecu to get the eruo/asian map thats in the ecu allready.
used gitar wire.
cloud 9
But it'll make more hp than the Oz ECU without a key
US= No K.I.S.S. Immobilser
The difference can be bridged out, and doesn't really matter if you drop in a PCIII.