Kawasaki Sportsbike Riders Club - Australia - Online Forum

One of these would be handy.. not at $140 though..

http://cgi.ebay.com.au/Kawasaki-ZX6R-ZX ... 56309d2b56

Was only talking about these last night, I am guessing you would have to buy one to see...... the pictures & description don't offer much detail

Paging Gazza

tremil points and a bar will give you the same result......although not as flash

Yeah I dont think it needs to be real sophisticated by the looks.

I can get steel, not stainless but other stuff no worries

i can make

I know someone with a lathe and could knock up the pins then you just buy a length of tube for the slide, I'll make inquiries later this week about it.

could make em at work but ill need some specs on size, etc

thats a good idea

Ill whip one of em up at work tomorrow

All I need is some steel

were would I get some

I reckon I could have a go, it might look a bit agricultural though

Bastards stole my idea. Here's one I made back in 1995 when I first got my 9. The only problem with it is that the distance (air gap) between the end of rear axle and the swingarm is different on the LHS to the RHS, one my old 9 anyway. So when you move from one side to the other, the angle of the aligment tool changes relative to the bike. I'm pretty sure there was some dude by the name of Pythagorus that I learnt about in school who reckons that will alter the distance measured. Does that make sense? I'll try and post another pic tonight to show you what I mean.

I just use the front wheel toe-in measurer thingy I made for the car
it looks like a cross between the evilbay item and Kevs....

Soooooo, who made one.????

I thought about it a lot, does that count?

Mick C wrote:I thought about it a lot, does that count?

Hey Mick, you want a job - plenty of that goes on here