Kawasaki Sportsbike Riders Club - Australia - Online Forum

Well as the 9 was sold I ended up keeping the 6. I have done the following mods to it so far:
Yoshi RS5 slipon, genuine rear cowl, removed pillion pegs, integrated tail light assy, crg levers, screen, gpr steering damper, speedo healer, k&n filter, pc111.

I was going to get the two bros twin setup but ended up getting the Yoshi cheap at the Mladin sale. The screen was supposed to be a dark smoke but turned up black. Wasn't sure about it at first but it's grown on me. It was cheaper to get a genuine rear cowl than one off ebay.

Dynoed at approx 114HP with downloaded map. 121.8HP after custom map.

Next on the list is braided lines and possibly swapping the calipers. Was thinking about rearsets but the stock setup is comfortable for me, so I may just get the heel guards anodised.

Very sweet looking bike, nice work

The screen looks good in black aswell

nice work, now polish the wheel lips

Wattie wrote:nice work, now polish the wheel lips

+1

then sell it to me!!!

robracer wrote:

Wattie wrote:nice work, now polish the wheel lips

+1

I've heard polished rims are a bitch to keep nice and shiney. But I'm guessing if I just do the lip it would not require that much work. Any suggestions where to get it done and cost or should I just buy a kit and do it myself?

just the lip is good, you spray it with silicone spray after cleaning, then when it gets dirty, just wipe away and re=apply silicone spray

my Z had machined lips, they were easier to keep nice than polished lips would be.

looking nice wardy. i think those flames are growing on me

HAWTTT!! nicely done

love that colour scheme, looks hawt !

Blurr wrote:looking nice wardy. i think those flames are growing on me

They're actually a tribal pattern not flames apparently. I think they went a bit overboard on the 10 but don't mind these ones.

In regards to the rims I think I will leave them as they are for a while. They are not just a plain red, they have metalic flecks through them which look quite good in person. Maybe next winter if I'm bored I may get out the stripper and polish.

Also I was going to mount the number plate near the rear shock, which makes the rear end look heaps better but decided against it to keep the boys in blue happy. I am happy with the integrated tail light assy though.

Wardy wrote:...integrated tail light assy, ...and pc111.

The screen ...

Nice work!

Few questions, the indicators are now in the tail light assembly right? Looks clean. What screen is that, i like the shape and been always meaning to get one. Lastly, how much for the pc111 and tune? I doubt id go that far but it is impressive.

nice wardy!

newbie question: what's that red box on the triplpe clamp?

tim wrote:nice wardy!

newbie question: what's that red box on the triplpe clamp?

That's a radial mount dampener.

121hp is pretty healthy for a 636. Well done!

That is one very, very, very sexy looking bike indeedi, really like it, dude, well done, good choice in keeping it I reckon