Page 1 of 2
Nuts wanted.!!!
Posted: Fri May 18, 2007 4:12 pm
by MadKaw
I'm after a couple of nuts...
M22 engine bolt lock nuts to be exact.
I need 2 of em and I can only get 1 from Parra Kawi. at $16 a pop.
Any ideas.?
The kawi part No. is 92015-1846 if anyone has any contacts...
Posted: Fri May 18, 2007 4:14 pm
by Wattie
erm take it to bolt master.
andf yes they have nuts too...
theres one at penrith.
i think there is a similar shop at north richmond too.
Posted: Fri May 18, 2007 4:34 pm
by Frank
There is a bolt master in Penrith, at the back of the Nepean Motor Group off of Mulgoa Road.
Re: Nuts wanted.!!!
Posted: Fri May 18, 2007 5:00 pm
by Smitty
MadKaw wrote:I'm after a couple of nuts...
...
ummm
you break yours................?
Posted: Fri May 18, 2007 6:45 pm
by SnypR
the wifes got em..
Posted: Fri May 18, 2007 8:11 pm
by robracer
Posted: Fri May 18, 2007 9:15 pm
by Smitty
SnypR wrote:the wifes got em..
...and she lost one.......
Posted: Fri May 18, 2007 11:04 pm
by Burky
Smitty wrote:SnypR wrote:the wifes got em..
...and she lost one.......
Sounds like someone is screwed
Posted: Sat May 19, 2007 2:07 pm
by Neka79
mate plenty of nuts in here!!
Posted: Sat May 19, 2007 2:35 pm
by Poyda
The guys at Nepean Boltmaster are damn good. If they haven't got it they should be able to get it quick
Posted: Sat May 19, 2007 5:38 pm
by mrmina
i'll see how much i can get them for from my bolt supplier.
Posted: Sat May 19, 2007 6:54 pm
by Smitty
mrmina wrote:i'll see how much i can get them for from my bolt supplier.
they sell MadKaw's nuts...????
Posted: Sat May 19, 2007 7:52 pm
by Neka79
mrmina wrote:i'll see how much i can get them for from my bolt supplier.
so wot did stace say??
Re: Nuts wanted.!!!
Posted: Sat May 19, 2007 10:18 pm
by Errol
MadKaw wrote:I'm after a couple of nuts...
M22 engine bolt lock nuts to be exact.
I need 2 of em and I can only get 1 from Parra Kawi. at $16 a pop.
Any ideas.?
The kawi part No. is 92015-1846 if anyone has any contacts...
To ensure you get the
right /interchangeable nuts, you need to supply the
Thread Pitch of the M22 nuts. ie M22(Dia) x 2.5(pitch) = metric course. M22x1.5 = Metric fine.
Or supply the male thread (bolt) to the nut'n bolt company for positive ID
.
Posted: Sun May 20, 2007 10:44 am
by mick_dundee
mrmina wrote:i'll see how much i can get them for from my bolt supplier.
this is the same bloke that supplies the bolts for your neck I assume?
