Page 1 of 1
ZX14 Engine anyone???????
Posted: Tue Jun 13, 2006 9:41 pm
by camel
It didn't take long.....but someone can't handle 1400cc of Kwaka power
http://cgi.ebay.com/ebaymotors/06-KAWAS ... 2231QQrdZ1
Posted: Tue Jun 13, 2006 10:42 pm
by dumber
only in america. wack it in a dune buggie or gokart
Posted: Tue Jun 13, 2006 10:53 pm
by hoffy
I can see someone trying to fit that in a GPX after last dyno day ????
Posted: Tue Jun 13, 2006 11:23 pm
by Neka79
farking tools wasting a good bike..i HATE that..
Posted: Tue Jun 13, 2006 11:23 pm
by Ratmick
...there's a couple of guys in the local buggy club who would be sniffing around that. They currently run ex-ZX9/R1/CBR929 motors in their buggies, I'm pretty sure someone has got a ZX-10-powered buggy in development, so I'm pretty sure a ZX-14 donk would go down a treat.
...however, seeing I do St Johns first-aiding at their events, and I've seen what a R1-powered buggy will do, I might not tell them this one's on offer
. It does look a hoot, but I reckon they are nuts...even with the 4-point harness, safety chains on the wrists, neck brace and roll cage.
If anyone's interested (and you have a spare engine lying around), the classes they race (and they are about to be registered as separate classes in CAMS) are on here:
http://www.torc.com.au/
I believe there's a few like-minded clubs around and as I said, it looks a hoot
.
BTW, they used to race Trikes and Quads, but they had too many accidents.
Posted: Wed Jun 14, 2006 7:30 am
by matchan
dumber wrote:only in america. wack it in a dune buggie or gokart
or throw it in a smart car, I'm sure I've seen a video of one with an eyeabuser motor in it
Posted: Wed Jun 14, 2006 9:52 am
by bonester
Should whack it into a ZX12r - probably fit straight in...
Posted: Wed Jun 14, 2006 9:53 am
by FrogZ
...be sweet in a quad.....
Posted: Wed Jun 14, 2006 12:29 pm
by zbeast
frogzx12r wrote:...be sweet in a quad.....
ZXR250/14........what a way to learn
Posted: Wed Jun 14, 2006 5:50 pm
by SocialSecurity
what, bike stacks only happen in america?
Posted: Wed Jun 14, 2006 11:00 pm
by mike-s
but that's just an excuse to take the piss out of them!
Posted: Thu Jun 15, 2006 12:23 pm
by kellz
hoffy wrote:I can see someone trying to fit that in a GPX after last dyno day ????
you read my mind. lol.
may need to upgrade the frame though.
Posted: Fri Jun 16, 2006 10:37 pm
by Neka79
kellz wrote:hoffy wrote:I can see someone trying to fit that in a GPX after last dyno day ????
you read my mind. lol.
may need to upgrade the frame though.
just weld on a swing arm support..ull be right...
Posted: Sat Jun 17, 2006 9:50 am
by Stretchy
Muzzys have brand new crated ZX14 engines on there web site.