Page 3 of 3
Re: What U Think Z1000?
Posted: Sun Dec 14, 2008 6:29 pm
by ProblemChild
Phil wrote:Wattie's (now PC's) Z made 122-123 - stock as the day it left the factory - from memory on Tex's dyno. That's a Dyno Dynamics type that will typically read lower than a Dynojet dyno. As Wattie says it doesnt matter a toss as long as the same dyno is used.
However I also agree that 105 or so sounds a little low
even stock.
i will have to see if i can make the next dyno day to see if da pipe made any difference .
Re: What U Think Z1000?
Posted: Wed May 12, 2010 7:27 am
by jess21
love those mirrors dude....
Re: What U Think Z1000?
Posted: Thu May 20, 2010 6:22 pm
by 4th
debaged tank does look good, i think most people would think its crash fixed at resale tho
was the ermax hugger, pan, bug screen kit expensive? best i have priced is 550$US plus freight
jess21 wrote:love those mirrors dude....
i was looking at getting some of these import ones, but im not sure if they would fit my protaper bars
http://global.ebay.com/BAR_END_MIRRORS_ ... 55555/item
Re: What U Think Z1000?
Posted: Fri May 28, 2010 8:43 am
by sneakypete
looking reeeally good...
Re: What U Think Z1000?
Posted: Fri May 28, 2010 6:17 pm
by s man
Firstly that bike is one smokin hot mofo of a thing!!
Secondly a 1000 should be putting out well in the high 120 130+HP
Either way dyno's are just a tuning tool.
One will say one figure, ride over the road to the other & the figure will be different..
Re: What U Think Z1000?
Posted: Sat May 29, 2010 8:22 am
by 4th
4th wrote:was the ermax hugger, pan, bug screen kit expensive? best i have priced is 550$US plus freight
ANYONE HAVE A BETTER RESELLER $$$?