Page 2 of 2
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Fri Jan 07, 2011 8:59 am
by plane
All I did was hit the rear guard with a stanley knife.
I traced out the line that I wanted to take first, then in I went. Once the initial incision was made, the cutting process was remarkably easy... It ended up looking like the Canadian model's rear guard.
Cheers,
Pete
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Fri Jan 07, 2011 9:19 am
by Nelso
That's the same as what mine is like but I added the rego label above the plate. I just realised I need to put the new label in the tube.
Sometimes I wonder why I am going to fit the fender eliminator since it looks fine the way it is.
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Fri Jan 07, 2011 9:28 am
by Phil
Mine is the same, I did it with Big Guy in the shed with a hacksaw
In the first photo you can see the line marked out, the the second the plate is back on.
BTW, looking at those photos I didnt even recognise my own bike
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Tue Jan 11, 2011 12:31 pm
by Screamin TE
Nelso, where did you get those indicators? They are the same as what i have on mine but i busted a couple in the off i had.
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Tue Jan 11, 2011 1:21 pm
by Nelso
From Bikebiz I think. These are them anyway.
http://www.bikebiz.com.au/products/Oxfo ... Arrow.html I have the long ones on my bike.
I also bought wiring adapters from this bloke
http://cgi.ebay.com.au/Kawasaki-Turn-Si ... 4148f489bc so I didn't have to cut up my wiring.
Re: ZRX Tail Tidy and Hugger - link for xmas bling bling
Posted: Tue Jan 11, 2011 1:26 pm
by Screamin TE
Cheers for that, ill book mark the site.
