Gday,
Well i paid a little more for my bike alarm as my mind frame was that with my insurance it was going to cost me at least $1100 in excess if someone stole it.... so i spent $800 on a bike alarm. Yes its probably alot of money but it has saved my bike numerous times so it is worth every cent of the money.
Well your probably wondering what you get for $800
The alarm itself, sensor units, aerial, pager, 2 key pads.
The bike alarm has two settings, one if you knock it, sit on it, try to lift it... the other if someone comes close to it (can adjust). It gives them three warnings and then screams its tits off. It also has the alarm on voltage drop of the input power.
Now when it goes off a second later your pager goes off (especially great in shopping malls.) and you run out (as quickly as you can in leathers and boots) and smack the fook out of the person who touched/breathed/looked/ or thought about any of the above. The pager is good for 1km as it is using cb. With this unit if for instance you have 6 bikes, you can link all of the alarms together to the same pager etc.
Now this alarm usually last just over 2 weeks without turning the bike on till the battery is low enough not to beable to crank the bike, bu the alarm is still working.
So to combat this i have put jumper pins into the rear of my under tray where i can hook the battery charger straight to it if need be without having to remove my seat etc to get to the battery.
That price also included the guy coming out to where ever you are to fit the alarm. It is the recommended alarm from kawasaki (well thats what they told me). It doesnt get you any discount on your insurance through nrma as they want satellite tracking on the bike to enable the discout to start.
Well the name of the alarm is Armed Gaurd GFORCE or
http://www.armedguard.com
Here is just a quick paste from the site on how it works.
The remote has two buttons on it. If the first button is pushed, the system and perimeter sensor becomes armed or if the second button is pushed, the system is armed, but the perimeter sensor is not armed. Pushing either button again disarms the system. A single loud CLICK is emitted when the system is armed and the turn signals flash once. A double loud CLICK is emitted when the system is disarmed and the turn signals flash twice.
The alarm module monitors the bike voltage for any sudden drops that would indicate an attempt to hot wire the bike. It also interrupts the starter circuit with a latching relay so that the starter will not function, even if the power lead to the alarm is severed by the thief. An internal, adjustable, sensor is built into the body of the alarm to detect tilt, motion, or a sudden shock to the bike. The remote controller uses code-hoping technology that prevents someone from receiving and retransmitting the codes to disable the system. An auxiliary sense wire and circuit is also provided to monitor other inputs, like when the saddlebags and/or trunk are opened. Additional inputs can be added to this auxiliary sense wire as well.
The microwave radar perimeter sensor has an adjustable range/sensitivity and it also has a warn-away function that gives the offending party two warnings within 8 seconds to back away before the systems alarms. If no more perimeter invasions are sensed within 5 seconds, the counter resets. After the third trigger of the perimeter sensor within 8 seconds, the system goes into full alarm. The warn-away audio warning consists of three clicks and flashes of the turn signals on the first event. The second event within 5 seconds triggers five rapid clicks and flashing of the turn signals. The clicks are loud enough to startle the offender, but are not so loud as to annoy anyone nearby. Maximum range of the perimeter sensor is about 10 ft, depending on where you install it.
The pager can be set to vibrate or beep when activated. Advertised range of the pager is up to ½ of a mile and the transmitter unit operates on the 27 Mhz frequency band with a transmitting power of 4 watts.
The unit draws 4milliamps of current when in the armed mode. The flashing LED draws another 1milliamps and the perimeter sensor adds another 12milliamps when activated. According to the folks at Armed Guard, they did extensive studies with Yuasa and Kawasaki in 2003 and have determined that the system can be safely left armed for 1-2 weeks with the perimeter sensor activated, and as much as 6 weeks without perimeter sensor activated, and the battery will remain within normal operating range. A battery tender device is recommended for any extended storage.
Anyway.. i definately think its the best bit of equipment i have put on the bike, definately makes it easier to walk away from her and know that you can come out swinging if someone wants it more than you.
My 2c