Hi
What is the set up with valve clearances on '04 z1000 . Shim under bucket or on top . Is there is special tool req"d to remove shims . Job is easy enough on older 70's zeds
Thanks
Kawasaki Sportsbike Riders Club - Australia - Online Forum
Australian Kawasaki Sportsbike Riders Discussion Forum - All Welcome, free and easy to join, just click "register" below - www.ksrc-au.com
valve clearances '04 Z1000
3 posts
• Page 1 of 1
valve clearances '04 Z1000
by Greenaz » Thu Nov 19, 2015 5:44 pm
- Greenaz
- Newbie
- Posts: 4
- Joined: Mon Jun 08, 2015 12:07 am
- Bike: Z900
- State: Western Australia
Re: valve clearances '04 Z1000
by Wattie » Fri Nov 20, 2015 7:57 pm
Shim under bucket mate.
Depending on kms, might not even need adjusting.
Pretty easy job.
Depending on kms, might not even need adjusting.
Pretty easy job.
Wattie #55
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
-
Wattie - VIP MEMBER
- Posts: 10041
- Joined: Mon Oct 31, 2005 12:23 pm
- Location: Bligh Park
- Bike: ZX10R
- State: New South Wales
Re: valve clearances '04 Z1000
by Wattie » Fri Nov 20, 2015 7:57 pm
No special tools rqd
Wattie #55
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
ZX10R "The Crim"
ZX10R "Gumby"
Proudly Supported by Allfixed Automotive 9634 1455
sam & srt, survived
RGM, left a message
-
Wattie - VIP MEMBER
- Posts: 10041
- Joined: Mon Oct 31, 2005 12:23 pm
- Location: Bligh Park
- Bike: ZX10R
- State: New South Wales
3 posts
• Page 1 of 1
Return to Z, ZRX, ER6 & other nakeds
Who is online
Users browsing this forum: No registered users and 0 guests